Garmin Nuvi 710 Instruction manual

Quick Start Manual
© 2007 Garmin Ltd. or its subsidiaries
August 2007 190-00859-01 Rev. C Printed in Taiwan
nüvi®700 Series
personal travel assistant

2
What’s in the Box?
nüvi GPS device and vehicle suction cup
mount.
Vehicle power cable to provide external
power, or an FM TMC trafc receiver to
provide external power and trafc information.
USB cable to connect the nüvi to your
computer. Your nüvi connects to your
computer as a mass storage device.
Dashboard disk to mount the suction cup
mount on your dashboard.
Ways to Charge Your nüvi
Use the vehicle power cable.
Use the USB cable.
Use an optional AC adapter.
•
•
•
SD card slot
Headphone/audio
out jack
Microphone
Power key:
slide to the left to turn the unit on/off;
slide to the right to lock the screen
SpeakerGPS antenna
Mini-USB connector
Serial number
External antenna connector
WARNING: See the Important Safety and Product Information guide in the product box for product warnings
and other important information.

3
Step 1: Mount the nüvi
1. Plug the vehicle power cable into the power connector
on the right side of the cradle.
2. Snap the cradle onto the suction cup arm.
3. Clean and dry your windshield and the suction cup
with a lint-free cloth. Remove the clear plastic from the
suction cup. Place the suction cup on the windshield.
4. Flip the lever back, toward the windshield.
5. Fit the bottom of your nüvi into the cradle.
6. Tilt the nüvi back until it snaps into place.
7. Plug the other end of the vehicle power cable into
a power outlet in your vehicle. Your unit should turn
on automatically if it is plugged in and your vehicle is
running.
8. IfyouareusingatrafcreceiverinEurope,securethe
trafcreceiver’santennatothewindshieldusingthe
suctioncups.(Thetrafcreceiverisincludedinsome
nüvi 710, 750T, 760, and 770 packages.)
WARNING: This product contains a non-user-replaceable lithium-ion battery. See the Important Safety and
Product Information guide in the product box for important battery safety information.
Check your state and local trafc laws before mounting. Currently, state laws in California and Minnesota
prohibit drivers from using suction mounts on their windshields while operating motor vehicles. Other Garmin
dashboard or friction mounting options should be used. See the Important Safety and Product Information
guide for more details.
Cradle
Power cable
Suction cup mount

4
Step 2: Congure the nüvi
To turn on your nüvi, slide the Power key
to the left. Follow the on-screen instructions.
Step 3: Acquire Satellites
Go outdoors to an open area, out of garages,
and away from tall buildings. Stop your
vehicle, and turn on the nüvi. Acquiring
satellite signals may take a few minutes.
The bars indicate GPS satellite
strength. When one bar is green, the nüvi has
acquired satellite signals. Now you can select
a destination and navigate to it.
Step 4: Use the nüvi
BA C D
E F
G H I
AGPS satellite strength.
BBluetooth
®
technology status.
CBattery status.
DCurrent time; touch to change time settings.
ETouchtondadestination.
FTouch to view the map.
GTouch to make a call when connected to a
compatible mobile phone (nüvi 710, 760,
and 770 only).
HTouch to adjust the volume.
ITouch to use the tools such as media
players, settings, and Help.
Finding Points of Interest
1. Touch Where to > Points of Interest.
2. Select a category and a sub-category.
3. Select a destination, and touch Go.
To enter letters contained in the name, touch
Where to > Points of Interest > Spell Name.
To search for a location in a different area,
touch Where to > Near.

5
Viewing the Main Pages
Touch View Map to open the Map page. The vehicle icon shows your current location.
Touch the map and drag to view different parts of the map. Touch anywhere on the map; an
arrow appears pointing at the object.
After you touch Go, the Map page opens. Your route is marked with a magenta line. As you
travel, your nüvi guides you to your destination with voice prompts, arrows on the map, and
directions at the top of the Map page. A checkered ag marks your destination. If you depart
from the original route, your nüvi recalculates the route and provides new directions.
Touch to save your
current location.
Map Page while Navigating a Route
Touch Arrival or Speed to
open the Trip Information.
Touch Turn In to view the
Next Turn.
Touch the text bar to open the Turn List.
Touch to zoom out. Touch to zoom in.
Touch Menu to return to
the Menu page.
Turn List Next Turn
Trip Information
Garmin
®
and nüvi
®
are trademarks of Garmin Ltd. or its subsidiaries, registered in the USA and other countries.
These trademarks may not be used without the express permission of Garmin. Windows
®
is a registered
trademark of Microsoft Corporation in the United States and/or other countries. Mac
®
is a registered trademark of
Apple Computer, Inc. The Bluetooth
®
word mark and logos are owned by the Bluetooth SIG, Inc. and any use of
such marks by Garmin is under license.

6
Adding a Via Point
1. With a route active, touch Menu on the
map, and touch Where to.
2. Search for the via point (extra stop).
3. Touch Go.
4. Touch Add as Via Point to add this stop
before your destination.

TIP: To add more than one stop, edit
the current route. Touch Where to >
Routes.
Using FM TMC Trafc
The trafc receiver is included in some nüvi
710, 750T, 760, and 770 packages.
If the nüvi is connected to the FM TMC
trafc receiver, connected to vehicle power,
and you are in a coverage area, the nüvi can
receive trafc delay information. For more
information, visit www.garmin.com/trafc.
When calculating your route, the nüvi
examines the current trafc and automatically
optimizes the route for the shortest time.
You might still be routed through trafc if no
alternative roads exist. If a severe trafc delay
occurs on your route while you are navigating,
the nüvi automatically recalculates the route.
The Map page displays or when there
is trafc on your route. The number in the
icon represents the number of minutes the
trafc has added to your route, which has been
automatically calculated into the arrival time
shown on the map.
1. On the Map page, touch or .
2. Touch toviewtrafcdelays.
3. Touch Avoid.

NOTE: You do not need to activate
the subscription included with your
FM trafc receiver (if it came with
one). The subscription activates
automatically after your nüvi acquires
satellite signals while receiving trafc
signals from the pay service provider.
Using Hands-Free Features
Bluetooth wireless technology is available in
nüvi 710, 760, and 770 only.
Hands-free phone features are available only if
your nüvi and your compatible mobile phone
have Bluetooth wireless technology. Not
all phones support all the hands-free phone
features the nüvi provides. To use the hands-
free features, you must pair your phone and
the nüvi.

7
Pairing Your Phone
1. Conrmthatyourphoneissupportedby
the nüvi. (See www.garmin.com/bluetooth.)
2. From the Menu page, touch Tools >
Settings > Bluetooth.
3. Touch the Add button.
4. Enableyourphone’sBluetoothcomponent
and enable Find Me/Discoverable/Visible
mode. These settings might be in a
Bluetooth, Connections, or Hands-free
menu.
5. Touch OK on the nüvi.
6. Select your phone, and touch OK.
7. Enterthenüvi’sBluetoothPIN(1234) in
your phone.
Calling a Number
1. Touch Phone > Dial.
2. Enterthenumber,andtouchDial.
3. To end the call, touch > End Call.
Receiving a Call
When you receive a call, a message appears on
the nüvi. Touch Answer.
Using Call Waiting
If you get a call waiting call, the nüvi displays
a message. Touch Answer. The rst call is put
on hold.
1. During the call, touch > Switch To.
2. Touch End Call to hang up; this does not
disconnect the call on hold.
Using the FM Transmitter
Before using the FM transmitter in your area, see
the FM transmitter legal notice in the owner’s
manual.
You can listen to your nüvi audio on your
vehicle’s FM stereo speakers. From the Menu
page, touch Volume > FM Trans >Enable
FM Transmitter. If you are using an FM
trafc receiver, touch Auto Tune, and tune
your stereo to the same channel. If you are not
using an FM trafc receiver or you are using
an MSN Direct receiver, select an FM channel
with a lot of static, and select the same channel
on the nüvi.

8
Loading Files on Your nüvi
Connect the USB cable to the mini-USB
connector on the nüvi and to an available USB
port on your computer. Your nüvi’s internal
memory and SD card appear as removable
drives in My Computer on Windows
®
computers, and as mounted volumes on Mac
®
computers. Copy and paste les from your
computer into the nüvi drives/volumes. When
you are nished transferring les, click the
Eject icon or drag the volume icon to
the Trash. Unplug your nüvi.
Listening to MP3 Files
Load MP3 les to the internal memory or SD
card.
Touch Tools > Media Player. Touch Source
to open the music player. Touch Browse.
Touch a category. To play the entire category
from the beginning of the list, touch Play All.
To play a specic song, touch the title.
To create, edit, and listen to playlists, touch
Browse > Playlist.
Locking Your nüvi
1. Touch Tools > Settings > Security.
2. Touch the button below Garmin Lock.
3. Entera4-digitPINanddrivetoasecurity
location.

NOTE: If you forget your PIN and
your security location, you must
send your nüvi to Garmin to get
it unlocked. You must also send a
valid product registration or proof of
purchase.
Resetting the nüvi
If the nüvi screen stops functioning, turn the
nüvi off and on again. If this does not help,
slide the Power key to the left and hold for
8 seconds. Turn the nüvi back on. The nüvi
should operate normally.
More Information
For more information about your nüvi, touch
Tools > Help. You can download the latest
version of the owner’s manual from
www.garmin.com. For information about
accessories, go to http://buy.garmin.com or
contact your Garmin dealer.