Gecko Aeware 3 in.tune panel User manual

in.tune panel housing
Designed to facilitate the installation
of in.tune onto a spa panel.
™
in.tune panel housing
30° mounting bezel for in.tune
am/fm receiver / mp3 / cd player
installation instructions

in.tune panel housing
in.tune panel housing
Warning
Introduction
The in.tune panel housing is a 30° embedded tting designed to
facilitate the installation of the in.tune player onto a spa panel.
When properly installed, this UL approved bezel system helps
to protect the in.tune player specially through packaging and
transportation of the spa. Made of durable and lightweight plastic,
the in.tune panel housing adds mounting exibility, ease of use and
better view angle.
WARNING
Before installing or connecting the unit,
please read the following.
DO NOT BLOCK VENTS OR RADIATOR PANELS.
Doing so may cause heat to build up inside and may result in re.
DO NOT USE FOAM TO ISOLATE THE UNIT.
Doing so may cause heat to build up inside and may result in re.
INSTALL UNIT 1" AWAY FROM OTHER SURFACES.
Make sure to leave a clearance of at least 1" from other surfaces.
FAILURE TO APPLY SILICONE MAY DAMAGE THE UNIT
AND SURROUNDING EQUIPMENT.
THE IN.TUNE MUST ALWAYS BE INSTALLED WITH THE
MOUNTING STRAP FIRMLY FIXED TO A SOLID PART.
Failure to do so may result in damage to the unit and annulment of
the warranty.
PRECAUTIONS
Accessory parts
Be sure to use only the specied accessory parts. Use of other
than designated parts may damage the in.tune player internally or
may not securely install the unit in place. This may cause parts to
become loose resulting in hazards or product failure.

in.tune panel housing
in.tune panel housing
Step 1
Using the drilling template supplied with the unit, determine the
mounting location and then stick the template on the location.
Mounting surface
Template
Once the desired location is established, place guide template and
with a hole saw, drill a starter hole at the outline of the template.
With a jigsaw, cut all around the edges of the template.
Then drill six 1/8" (3 mm) mounting holes in the exact position
according to the drilling template.
Safety: Protective eyewear should be worn by anyone operating
equipment used in the installation of the in.tune mounting bezel.
10 1/2"
5 3/4"




Installation instructions

in.tune panel housing
www.aeware.ca
in Canada, available through
Gecko Electronics Inc.
450 des Canetons, Quebec City (Quebec
)
G2E 5W6 Canada,1.800.78.GECKO
in U.S.A, available through
Spa Builders Systems Group
9225 Stellar Court, Corona
CA, USA 92883, 1.866.639.7274
9919-100608-C
Step 2
Make a silicone joint between
the installation location and
the enclosure (to avoid water
leakage). Apply silicone all
around the enclosure. Let the
silicone dry and remove excess.
Note: Failure to apply silicone
may damage the unit and
surrounding equipment!
Step 3
Use 6 oval head stainless steel
screws #10 x 1 1⁄4" as well as 6
stainless steel nishing washers
#10 to x the enclosure.
Installation instructions
Step 4
Insert the mounting sleeve into
the hole (installation opening).
Note: See in.tune user manual
for complete installation
instructions.
Important:
The in.tune must always be
installed with the mounting
strap rmly xed to a solid
part. Failure to do so may re-
sult in damage to the unit and
annulment of the warranty.
Note: See in.tune manual for
more details.

5 3/4"
145.697
10 1/2"
266.905
in.tune panel housing drilling template