George & Willy HANGING DRYING RACK User manual
Quite popular in alpine huts, a traditional system used by
climbers to dry their damp clothing overnight.
It made sense to bring this idea into the home - eliminating
any worry of wet washing on the line, shrinking in the dryer
or cluttering your floor space.
Suspended using a pulley system that utilities the warm air
trapped in the ceiling, The Hanging Drying Rack is a fun and
functional solution for drying your laundry.
Enjoy
George & Willy
HANGING DRYING RACK
Where you install your product depends on its material/s.
Wooden and Steel Products: We recommend using these
products inside or under a shelter where they are protected
from any exposure to rain or water.
Aluminum Products: These products are non-corrosive and
suitable for use outside.
Chalk Products: You should use traditional dry chalk. We
don't recommend using liquid chalk pens on our products.
Transportable Outdoor Signage: If there is exposure to wind,
we recommend bringing signage inside to protect it from the
extremes. We offer Sandbags to help support your product in
moderate wind conditions.
CARE GUIDE
COMPONENTS
2 x Side Bar
12 x Dowel
2 x Rope
1 x Cleat
3 x Pulley
14 x Large Screws
18 x Small Screws
1 x Allen Key
Please use a qualified professional to ensure safe assembly and
installation of this product. Before you start assembly please lay
your Hanging Drying Rack out on the floor like above, ensuring
that the rope is not twisted and in the correct position before
installing the dowels.
1
Please ensure that the logo is
facing outwards when positioning
the frame for assembly.
Once you are happy your Hanging Drying Rack is in the correct
position place the dowels in the middle evenly so they match up to
the correct holes on the outside brackets, using the Allen key to
tighten the screws.
2
Select a suitable location to install the Hanging Drying Rack.
Ensure the chosen space allows enough room for the rack to be
raised and lowered easily.
3
Screw Pulley into the ceiling. Make sure the pulley is secured
to a beam.
1
1
4
Install pulley 1085mm back from pulley . Ensure they are
perfectly aligned.
21
1085mm
(Centre to center)
2
1
Screw Pulley into the ceiling. Make sure the pulley is secured
to a beam.
5
6
Install Pulley further back from pulley , close to the
Corner of the ceiling and wall. Ensure all three pulleys are
perfectly aligned.
2
3
3
Install the Rope Cleat vertically below pulley on the wall. Please
ensure the screws find a stud. All three pulleys and the rope cleat
must be aligned.
3
7
8
2
A
31
Thread Rope through Pulley . Continue across to pulley
and then through pulley .
2
A
3
1
9
Thread Rope through Pulley . Continue across and
through pulley . Pull both ends of rope ( ) until the
Hanging Drying Rack is raised off the ground. Adjust each end
accordingly until the rack becomes level in the air - A builders
level should be used for complete accuracy.
+
2
B
B
B
3
231
A
Raise the Hanging Drying Rack to the desired height attended for
use (chest height recommended). Tie a knot in the two ropes just
behind pulley .This stops the rack from lowering any further.Tie
off rope around the cleat. Cut any excess rope off and melt the
ends for a clean and tidy finish.
10
3
3
We recommend tying two separate knot positions to sit under
the cleat. Trim any excess rope off.
11
12
To keep excess rope out of reach, loop the rope up over the cleat.
Warning:
Please note that when the Hanging Drying Rack is in its up right
position, take extra care when lowering as the weight of the rack
will increase when fully loaded with garments when off the cleat.
The minimum height of the cleat needs to be installed at
170cm/67.0" from the ground. Allow for the droop of the loop to
sit over the cleat once it is pulled to its correct position. When
the rack is in its highest position no rope should hang lower than
140cm/55".
We recommend increasing the cleat height if it is still in reach of
young children.
The George & Willy Hanging Drying Rack comes with Lifetime
Warranty on parts. In association with the product, George &
Willy makes no warranties of any kind, either express or implied,
including but not limited to warranties of merchantability, fitness
for a particular purpose, of title, or of non-infringement of third
party rights.
George & Willy Ltd holds no liability for any harm or damage that
is caused by incorrect installation or use of a Hanging Drying
Rack. The Hanging Drying Rack must be installed by a certified
professional who will be able to advise the correct type of fixing
for the ceiling that it will be installed into. Please be sure to install
the wall cleat in a position where the rope is not accessible to
small children.
DISCLAIMER
CONTACT US
sales@georgeandwilly.com
www.georgeandwilly.com
@georgeandwilly
www.pinterest.com/georgeandwilly/
THANK YOU
Don’t forget to tag us on Instagram @georgeandwilly
For 10% off your next purchase, use the discount code:
WITHTHANKS
Table of contents
