GIGAMEDIA GGM WAPS1 User manual
www.gigamedia.net
GGM WAPS1
300 MPBS 2, 4G –WIRELESS ROUTER
Quick Guide
1- Hardware and Operation mode Instruction
Thanks to its web Interface, you can easily configure your Wireless Router to connect to your
Provider.
DC: Power Supply 5v/1A (optional)
WAN Port: Used to connect to the Internet Port
LAN: Linked to the LAN
www.gigamedia.net
WPS Button: Press 1 to 2 seconds for WPS (Wi-Fi Protected Setup)
Reset: Long Press (about 15 seconds) for Reset –Data Revert to Default
LED Indicator :
Green: Power Indicator, wireless router working
Blue: WiFi Indicator, wifi signal transmit
2- LOGIN
Connect your PC with the LAN Port then login Web Management with Internet Explorer or Google
Chrome:
You must configure your PC with a fixed IP address 192.168.188.XX (X between 2 and 253)
IP Address by default (LAN): http://192.168.188.253
Identification : admin
Password : admin
www.gigamedia.net
3- Configuration
By default, this router is in Access Point Mode.
For Quick Configuration, please use Advanced Settings / Quick Configuration:
a) Gateway Mode
Click “Gateway Mode” under following picture and choose the right WAN access type, then input the
right SSID, Channel, key as like.
b) AP Mode
Plug and Play to transmit wireless signal for wireless end users from wired networking. In this part,
user can mark the AP’s location and name for easy problem checking. Then can change SSID, Key,
Channel as request.
www.gigamedia.net
c) Advanced
System Status
Click “ Advanced Settings”, will show wireless router’s status, such as firmware version, build time,
System uptime...
Wireless Setting:
A. Basic Settings: In this part, user can check router’s SSID, disable or enable router’s SSID, modify
Channel, Security..
www.gigamedia.net
B. Virtual AP: in this part, user can set 3 more SSID for this wireless router, the steps showed as
follow:
C. In Access Control, user can allow/drop some MAC address to access into this router
D. Advanced Settings: User can set RF Output power, BandWidth, Max users...
www.gigamedia.net
Network Setting
LAN Settings and WAN Settings showed as follow, users can set based on request.
Firewall
In this wireless router, there are IP/Port Filtering, MAC Filtering, URL Filtering, Port forwarding and
DMZ Settings; user can choose the right firewall mode based on their request.
