1
ORBIS EXTENDED POST BRACKET
Installation Guide
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
A. B. C.
Offer Rear Bracket (1) into
position on the post, ensuring it is
in the correct orientation.
Tighten the parallel
Grub Screws (2*) to secure
Bracket in place.
Offer Extended Bracket (3*) into
position, and feed the Long M8
screws (4), with M8 washers (5)
through xture holes from secured
Rear Bracket side.
Ensure that personnel carrying out this installation have the relevant
qualications/certicates.
Ensure that all relevant personnel read the points listed within this leaet and
that a copy is given to staff involved with the installation and maintenance of
this product.
Please refer to ‘The Manual Handling Operations Regulations 1992’.
Glasdon recommends that a full Health and Safety analysis is carried out prior
to installation.
!
KIT CONTENTS
1 - Ø40/50/60mm Rear Bracket x1
2 - M6x16 Grub Screws x2 *
3 - Ø40/50/60mm Extension Bracket x1 *
4- M8 Long Socket Button Screw x4
5- M8 Washers x8
6- M8 Nyloc Nut x4
* Extension kit only (for Orbis with Lid)
EQUIPMENT REQUIRED
- Ø13 Spanner
- 5mm Allen Key
- Personal Safety Equipment (gloves, safety boots etc.)
23
4
5
1
Illustrations are for ‘Extended’ kits (ie Orbis with lift up Lid).
For Orbis without the Lid, Items 2 and 3 are not required or included
ORBIS POST MOUNTING KIT
FOR Ø40/50/60mm POSTS
