Granberg 343 User manual

2021-02-20
Installation instructions Changing table 343
Products
Shower and changing tables
Changing table 343
Changing table 343 - bathtub
Granberg Interior AB - Box 6112 - 600 06 Norrköping - SWEDEN
Tel: [phone] - E-mail: [email protected] - Internet: www.granberg.se

Content
1. Mechanical construction
2. Delivery modules
3. Electrical connection
4. Location of changing table
5. Functional test
Granberg Interior AB - Box 6112 - 600 06 Norrköping - SWEDEN
Tel: [phone] - E-mail: [email protected] - Internet: www.granberg.se

1. Mechanical construction
1. Motor
2. Mattress
3. White seamless Dupont™ Corian® with integrated border
4. Stand with adjustable feets
2. Delivery modules
The changing table is delivered assembled on a pallet.
343 - Without bathtub 343 - with bathtub
3. Electrical connection
The changing table must be connected to a nearby main switch.
If the table is installed in a wet room, wet room regulations must be observed. The motor power supply must always
be provided with an earth fault circuit breaker.
Connect the table to a 230V 50Hz power outlet. The outlet must be out of reach of children, remembering that the
changing table surface can be raised and lowered.
Cables must be routed and fixed with care to avoid the risk of pinching.
* Power requirement 230 W.
Electrical connections must be made by a qualified electrician.
Granberg Interior AB - Box 6112 - 600 06 Norrköping - SWEDEN
Tel: [phone] - E-mail: [email protected] - Internet: www.granberg.se

4. Location of changing table
Take care to locate the changing table so as to avoid pinching hazards. The distance to any adjacent fitting must be
at least 50 mm.
If the distance from the changing surface to a wall or an adjacent fitting is less than 50 mm, a pinching hazard exists.
It is the responsibility of the installer and the user to locate the changing table so that pinching hazards are avoided.
Adjust the feet so that the table is standing stable at the floor.
5. Functional test
Minimum distance to any adjacent fitting must be at least 50 mm.
If the distance from the changing surface to a wall or an adjacent fitting is less than 50 mm, a pinching
hazard exists.
Check that the changing table is firmly in place. If necessary, adjust the adjustable feets under the frame.
Run the changing table down and up all the way to respectively end position. Check that it moves freely,
without hindrance and jarring sounds.
Check that no cables are jammed.
If the changing table does not reach the lowest position:
Press the down button for 5 seconds until the control box clicks. When the control box clicks the
synchronisation is ok.
Model with bathtub:
Run the changing table to the end position and make sure the hoses are long enough above the fixing point.
Powered by TCPDF (www.tcpdf.org)
Granberg Interior AB - Box 6112 - 600 06 Norrköping - SWEDEN
Tel: [phone] - E-mail: [email protected] - Internet: www.granberg.se