Great day Ride-N-Rest RR605B User manual
PAGE 1 OF 3
RIDE-N-REST
MODEL: RR605B
READ ALL INSTRUCTIONS BEFORE USING THE RIDE-N-REST
NOTE: Failure to read instructions before use could result in injury or death.
Instructions for Installation and Use:
FIG. 1
FIG. 1
FIG. 2
PAGE 2 OF 3
CONTENTS:SEE FIG. 1
4 –SLIDING MOUNTING BRACKETS
4 –RIV-NUT PLATES
4 –2” QUICK CLIP PINS
6–1” MULTI PLUGS
8 –1-4” X 2 3/4” BOLTS
8 –1/4” X 1 3/4” BOLTS
8 –FLAT WASHERS
1 - RIDE-N-REST FRAME ASSEMBLY WITH
CUSHION
STEP 1 –
SLIDE THE 4MOUNTING BLOCKS
ONTO HORIZONTAL BARS OF
RIDE-N-REST FRAME. SEE FIG. 2
FIG. 3
FIG. 4
FIG. 5
FIG. 6
PAGE 3 OF 3
STEP 2 –
ATTACH 4SLIDING MOUNTING BLOCKS IN
DESIRED POSITIONS USING 4QUICK CLIP
PINS PROVIDED. SEE FIG. 3
STEP 3 –
USING A RUBBER MALLET OR
HAMMER, DRIVE THE 6–1”
MULTI PLUGS INTO OPEN ENDS
OF THE HORIZONTAL BARS OF
THE RIDE-N-REST FRAME. SEE
FIG. 4
STEP 4 –
POSITION RIDE-N-REST FRAME
ONTO CENTER OF ATV REAR RACK
TO MAKE SURE THE 4SLIDING
MOUNTING BLOCKS ARE IN THE
PROPER POSITION FOR RIDE-N-
REST TO BE SECURED TO ATV
RACK. SEE FIG. 5
STEP 5 –
ATTACH RIDE-N-REST SLIDING
MOUNTING BLOCKS TO ATV RACK
USING 4–RIV-NUT PLATES, 8–
FLAT WASHERS AND 8–1/4” X 1
3/4” BOLTS OR 8–1/4” X 2 3/4”
BOLTS (DEPENDING ON THICKNESS
OF ATV RACK). FINGER TIGHTEN
BOLTS UNTIL SNUG, BUT NOT
COMPLETELY TIGHT. SEE FIG. 6
FIG. 7
FIG. 8
FIG. 9
NEVER USE THE RIDE-N-REST FOR ANY PURPOSE OTHER THAN INTENDED.
For more information about this or other products, contact us at:
Great Day, Inc.
604 Kimbrough Dr. * Tallulah, LA 71282 * (866) 649-1918 * www.greatdayinc.com
STEP 6 –
RE-CHECK RIDE-N-REST TO BE SURE
IT IS CENTERED ON ATV RACK AND
TIGHTEN BOLTS SECURELY USING A
7/16” WRENCH.
SEE FIG. 7
STEP 7 –
TO SECURE RIDE-N-REST CUSHION,
REMOVE THE 2FRONT QUICK CLIP
PINS FROM THE MOUNTING BLOCKS,
PIVOT CUSHION TO DESIRED ANGLE
AND PIN VERTICAL SUPPORT BARS
TO HORIZONTAL FRAME BARS THEN
REPLACE QUICK CLIP PINS. SEE FIG.
8
STEP 8 –
TO LAY BACKREST IN
HORIZONTAL POSITION REMOVE 2
QUICK CLIP PINS FROM VERTICAL
SUPPORT BARS, LAY BACKREST
FLAT AND REPLACE QUICK CLIP
PINS INTO SLIDING MOUNTING
BLOCKS.
SEE FIG. 9
