Havis-Shields Universal Side Mount C-TCB-19 Configuration guide

C-TCB-19-INST-8-05
INSTALL INSTRUCTIONS C-TCB-19
UNIVERSAL SIDE MOUNT
TOOLS REQUIRED:
3/16” Allen wrench
3/8” Standard Socket Set
3/8” Ratcheting Wrench
Powered drill w/ drill bit set
Open-end wrench set
HARDWARE:
QTY DESCRIPTION PART #
1 Pole support assembly CM93071-19
1 Telescoping pole assembly CM93072-1
8 ¼-20 Nylock nut GSM30016
16 ¼” Flat washer GSM31005
8 ¼-20 x ¾” Hex head bolt GSM33001
Always!
 Read all instructions before installing any Havis-Shields Equipment Corp products.
 Check for obstructions (Wire, brake lines, fuel tank, etc.) before drilling any holes!
 Use hardware provided with install kit
SUB ASSEMBLY:
1. Confirm receipt of all hardware and components.
2. Determine location to mount TCB.
INSTALLATION:
1. MOUNT SUPPORT BRACKETS:
• With location determined, mark mounting holes using
lower support bracket as template.
• Drill ¼” holes on these marks.
• Attach lower support bracket to desired surface using ¼-20
x ¾” hex head bolts, washers and nylock nuts.
• Following same procedure for lower support bracket mark
and drill holes for upper support bracket.
• Mount optional C-3090, computer-mounting platform, to
telescoping pole assembly using hardware and instructions
provided with C-3090.
Upper
Support
Bracket
Lower
Support
Bracket
Telescoping pole
assembly