Havis-Shields Heavy Duty Trak Mount C-TM-GMC User manual

1
C-TM-GMC_INST_4-08
INSTALL INSTRUCTIONS C-TM-GMC
HEAVY DUTY TRAK MOUNT
2000-2008 CHEVROLET/GMC SUBURBAN/TAHOE,
YUKON XL/YUKON, SILVERADO/SIERRA
• Ratchet Wrench
• Sockets - 7/16”, 11 mm, 15 mm
• Open End Wrench- 7/16”
TOOLS REQUIRED:
QTY: DESCRIPTION: PART #:
1 Front transmission hump bracket C-B24
1 Rear transmission hump bracket C-B39
1 32” Extruded Trak mount C-TM-32E
2 Extrusion end caps CM93064
16 1/4” x 3/4” hex head bolt GSM33001B
8 1/4” Serrated nut GSM30023B
8 1/4” Flat Washers GSM31005B
HARDWARE:
Always!
• Read all instructions before installing any Havis-Shields Equipment Corp products.
• Check for obstructions (Wire, brake lines, fuel tank, etc.) Before drilling any holes!
• Use hardware provided with install kit
• For product support: visit the Install Instructions Section of our website at
http://havis.com/Installation/Installation.html, email [email protected]
or call 1-800-524-9900.
LINE DRAWING:
C-B24 Front
Hump Bracket
C-B39 Rear Hump
Bracket
C-TM-32E
Trak

C-TM-GMC_INST_4-08
2
Remove OEM trim panel covering front inner
seat bolts on driver and passenger sides.
Remove seat bolt nuts.
15 mm socket required.
Installation:
Remove OEM trim panel covering rear inner
seat bolts on driver and passenger sides.
Remove seat bolt studs.
11 mm socket required.
Loosely pre assemble front hump bracket
with 1/4” x 3/4” bolts and flat washers, then
position it under the OEM front seat brackets.
Loosely pre assemble rear hump bracket
with 1/4” x 3/4” bolts and flat washers, then
position it under the OEM rear seat brackets.
Determine the position of Trak desired and
mark location with a pencil on the hump
brackets.. Remove the front and rear hump
bracket cross support.
Insert 1/4” x 3/4” bolts into the bottom of Trak.
Line up Trak on cross supports where previously marked.
Use 1/4” serrated nuts to attach.
Reattach Trak with cross supports back onto seat brackets.