Herman Miller Nelson H763SCWALBNS Administrator Guide

Herman Miller Nelson Bubble Lamp Series Assembly Instructions1Part # 1BH75W Rev. A
Parts Included
Tools Required
HermanMiller
Nelson™Bubble Sconce Lamp
How to assemble your lamp
Lamp Shade, support tube and mounting block. Power cord
with weight.
(2) 2” Flat Head Wood Screws
Power Driver Phillips Driver Bit Phillips Screw Driver Pencil
Have someone hold the support tube and shade while you mount the block.
Step 2
.
Carefully pull upward from the corner of the box to remove your lamp parts.
.
Leave each part wrapped until mounted in order to avoid scratching.
.
Designate an area where the lamp is to be hung. A wall stud is recommended.
Use a stud nder for accuracy and strike a light pencil line using a small level
to ensure wood block gets installed straight.
Step 1
Important Safety Instructions
This lamp has a polarized plug, (one blade is wider than the other), as a
feature to reduce the risk of electric shock. This plug will t in a polarized plug
outlet one way. If the plug does not t fully in the outlet, reverse the plug. If it
still does not t, contact a qualied electrician. Never use with an extension
cord unless plug can be fully inserted. Do not alter the plug.
Please remove lamp from
bag before using.

Herman Miller Nelson Bubble Lamp Series hermanmiller.com/care-and-assembly Assembly Instructions2Part # 1BH75W Rev. A
Pull the wood piece down until it is o the tube and place it on the wall where
you would like the shade to hang. Use drywall inserts if a stud is not available.
Step 3
,
Put the screws through the pre-drilled holes in the wood block. You will need to
have an assistant help hold the cord o to the side so you have an obstruction -
free entry into the holes.
.
Slide the tube back into the wood block. It will stop at the thin ring attached to
the tube.
Step 4
Slide weight down closer to the floor for a clean cord line.
Step 5 Step 6
Plug power cord into an appropriate outlet and enjoy your Nelson Bubble
Lamp.