hernest H200114 User manual

USER MANUAL
1
Caution
Please consult the professionals before installation or repairing. The company takes no liabilities for any damage or
injuries that occur during the installation of the pipes, floor, wall and tub.
Thank you for shopping with Hernest, please read this user manual thoroughly for your full under-
standing, installing, and application of the product. Please have this user manual well-reserved
for future reference.
Before Installation
Check the package and ensure that all parts are included. If any part is missing or damaged, please contact us.
Do not disassemble the main body, as it has been installed & commissioned correctly & precisely before leaving
the factory.
Shut off the main water supply before the installation.
Do flush the water supply lines to remove any dirt and debris before installation(IMPORTANT).
Make sure to connect the hot/cold inlet pipe correctly. If standing in front, usually the hot water pipe connects to
the left and the cold water pipe to the right.
Check for leaks and make sure every joint is safely sealed after the installation,
Turn on the water supply and flush the water pipes for 3 minutes to make sure it works well before putting it
into use.
SKU:H200114
Single Hole Kitchen Basin Faucet

Ideal pressure: 1.0Mpa
Working pressure: 0.05-1.0Mpa
General Flow: <0.1Mpa (0~9.0L/min)
Hole size: 33~35mm(1.3”~1.4”) in diameter.
2
Basic Parameter
Part List
⑦Cold/Hot inlet hose
②Sealing ring
③Shank
④Rubber mat
⑤Washer
⑥Lock nut
①Faucet
1 1 1 1 1 1 2
Quantity
Number
Item Standard accessory
③②① ④ ⑤ ⑥ ⑦
Check the parts

3
1Remove the table lock group and put the
sealing ring into the groove to the
bottom of the faucet, then screw the
shank to the bottom thread of the faucet
body, then insert the whole part into the
table hole.
2Set up table lock group through the
water inlet hose respectively to the main
faucet and tighten them on the shank of
the main body, and tighten the two
locking screws with a screwdriver.
Table
Table
3After finishing the faucet installation,
connect the inlet angle valve according
to the item 5 connection diagram of the
cold/hot water inlet hose and angle
valve.
Installation Instruction
Table

When connecting the inlet hoses and the corner valve
Caution with Inlets and Valve
4
1Drain the dirty water in the pipelines
before connecting the nozzle with water
inlet pipe, then turn off the water flow.
3After connecting the inlet hoses to the
angle valve, connect the hot and cold inlet
pipes respectively. you are advised to use
one wrench to rotate nut of the hose and
use another wrench to prevent the inlet
hose from twisting.
2After the connection, the inlet hose
should not be bent, twisted or stretched
to avoid leadage or breaking and other
dangers.
For more detail information, please check out www.hernest.com
It will be our pleasure to have your visit.
After-Sale Service
If you have any issues with the product, please feel free to contact us online or by phone for customer service.
Phone Number: [phone]
Service E-mail: [email protected]
www.hernest.com