Hohner Hoodoo Hand User manual

By
OWNERS MANUAL
Ó2007 Hohner, Inc.
1000 Technology Park Drive
Glen Allen, VA 23059
www.hohnerusa.com
www.hoodoobyhohner.com

System Components
All Hoodoo Hand systems include:
·HH1R UHF Dual-Diversity Wireless Receiver
·HHT100 Wireless Belt-pack Transmitter
·HHD135-400 Class 2 Power Transformer (may vary by country)
·LAVHH1 Mini-Lavalier Microphone designed for Harmonica Use (T3 Connector)
·2 Patented “Hoodoo”Ring Clips for perfect Microphone placement
·2 “AA”Batteries
·5 ft. ¼”to ¼”line cable (for connection to PA or Amplifier)
HH1R Wireless Receiver
Front Panel
1. Power indicator
2. Channel “A”Antenna LED Lamp –lights steadily when engaged
3. Channel “B”Antenna LED Lamp
4. “NORM”Audio Level Indicator –will light when level is nominal
5. “PEAK”Audio Level Indicator –lights when input is overloaded
- If Lit, Adjust Sensitivity on HHT100 Transmitter
6. Output Level Control –Turn clockwise to increase volume

HH1R Wireless Receiver
Rear Panel
1. XLR Balanced Output –connect to FOH PA system
2. AC Adaptor Jack (for use with included HHD135-400 power supply)
3. Mute Level
- This control is typically pre-adjusted from the factory; if you experience any interference, adjust
clockwise until “NORM”audio level light goes out; back off slightly.
4. ¼”Unbalanced Output –for connection to FOH PA or Amplifier
(recommended use –connect to the Hohner “Hoodoo Box”Class “A”Tube amp, designed
specifically for harmonica!).

HHT100 Transmitter
1. Antenna
2. Power Switch (ON/OFF/STANDBY)
3. Sensitivity Switch (Mic Level, 0dB, -10dB)
4. Input –T3 connector (for use with included
LAVHH1 microphone
5. Low Battery Indicator Light
Wearing the HHT100 Transmitter
Clip the transmitter to belt (1), or slide guitar/harp
belt strap through the transmitter clip (2) as shown.
For Best results, slide the transmitter until belt is
pressed against the top of the clip.

TIPS FOR OPTIMUM PERFORMANCE
·Maintain a line of sight between transmitter and antenna
·Avoid placing the receiver near metal surfaces or any digital equipment (Cd players, MP3 players, computers, etc.)
·Keep the receiver away from the wall and at least 3 ft. (1m) from the ground
·Cellular telephones and two-way radio can cause interference to the transmitting frequencies
Changing the Batteries
Expected life for two Alkaline batteries is
approximately 8 hours. When the transmitter Battery
indicator light glows red, the batteries should be
changed immediately, as shown to the left.

TROUBLESHOOTING
ISSUE
Indicator Status
Solution
No Sound or faint sound Transmitter ON Indicator Turn On Transmitter
Stop flashing Verify that the +/- indicator on the battery match transmitter
terminals
Power Indicator Off
Verify AC adapter is securely plugged into Wall outlet and connector is
plugged into DC input on rear panel
Receiver NORM indicator glows Turn receiver volume up
Adjust sensitivity switch on transmitter
NORM indicator OFF with transmitter Check proximity of metal objects
ON
Transmitter low battery Replace Batteries
Indicator ON
Distortion or unwanted Receiver NORM indicator ON
interference Remove nearby sources of RF
Noise Bursts (MP3 players, cell phones, etc)
Distortion level increases
Transmitter low battery indicator ON Replace batteries

SPECIFICATIONS:
LAVHH1 Mini Lavelier Microphone
·Element: Condenser
·Polar Pattern: Omni-Directional
·Sensitivity:-55 to +3 dB
·Output Impedance: 1.5KOhm +/- 30%
·SPL Max: 130dB
·Power Supply: 1.5V-10V DC
·Cable: 1.5mm X 1.2m
·Weight: 25g
·Mic Dimension: 6mm
Fits into Patented “Hoodoo”Ring Clip
400mA
HHT100 Transmitter
·Audio Level maximum: 0 dBV ~ +20 dBV
·Gain Adjustment Range: 30 dB
·Input Impedance: 5 KOhm
·Power Requirement: two “AA”Alkaline Batteries
·Average Battery Life: >8 hours (Alkaline)
·Dimensions: 85 X 65 X 23mm
3.35”H X 2.6”W X .9”D
HH1R Receiver
·Audio Output Maximum (1 kHz):
oXLR: 200 ohm
o¼”Kohm
·XLR Out:
oPin 1 –Ground
oPin 2 –(+)
oPin 3- (-)
·Sensitivity: <-92dB
·Power Requirement: 12-18VDC 400mA
(included)
·Dimensions: 235 X 118 X 44mm
9.25”H X 4.65”W X 1.75”D

Manufactured in China exclusively for Hohner Inc.
This Product is certified by the manufacturer to be RoHS compliant.
Due to ongoing product development, product specifications are
subject to change without prior notice.
PN #HH1L1107.1US