6
1
2
Add Base Station
Add Camera
1. Connect your mobile device to the same router network that your base
station will be connected to (must be 2.4GHz frequency network)
2. Connect the base station to power supply using the included USB cable
and power adaptor
3. Use the ethernet cable to connect the WAN port of the base station to
your router's LAN port.
4. Open Home Zone Smart App, click the top right “+” to add device
5. Select “Base Station”, and follow the instructions to add the base station.
6. The indicator light on the base station should display solid green after
syncing correctly.
1. Turn the power switch to the On position for all cameras one by one,
then the cameras will beep, and the indicator light of the camera starts to
flash red; If the indicator light does not flash red, please press and
hold the reset button for 5s to reset the camera.
2. Enter the Base station interface on the app, click the “+Add Device”
button, then the base station will be in pairing status. Or press the SYNC
key of the Base Station, to add camera automatically. The Indicator
light will flash green.
3. When the camera successfully pairs to base station, a prompt
will be heard from camera and camera’s indicator light will turn
green. The added camera will then be displayed on the app.
4. If camera could not pair to the base station, please add the camera
again following the above ①②③steps.
Adding Device
