Hoover HBFUP 130 K Mounting instructions

HBFUP 130 K

6
6
14
15
Regulations, Standards, Guidelines 16

Important safety instructions
Prior to initial start-up
Refrigerant
Caution:risk of fire
The refrigerant isobutene (R600a) is contained within the refrigerant circuit of the
appliance, a natural gas with a high level of environmental compatibility, which is
nevertheless flammable. During transportation and installation of the appliance,
ensure that none of the components of the refrigerant circuit becomes damaged.
The refrigerant (R600a) is flammable.

WARNING!--- Necessity to allow disconnection of the appliance from the supply after
installation. The disconnection may be achieved by having the plug accessible or by
incorporating a switch in the fixed wiring in accordance with the wiring rules.

Position the appliance away from sources of heat such as stoves, radiators, direct
sunlight etc. Maximum performance and safety are guaranteed by maintaining the
correct indoor temperature for the class of unit concerned, as specified on the rating
plate. This application perform well from N to ST. The Appliance may not work properly
if it is left for a longer period at a temperature above or below the indicated range.
IMPORTANT! -There is a need of good ventilation around the fridge for easy
dissipation of heat, high efficiency of refrigeration and low power consumption.
For this purpose, sufficient clear space should be available around the fridge.
It is advisable for there to be 75mm separating the back of the fridge to the wall,
at least 100mm of space at its two sides, height of over 100mm from its top and
a clear space upfront to allow the doors to open 160 .

IMPORTANT! –In order to make the most of the volume o
frozen-food storage compartment, the user can removed one or
more drawers, out of the appliance, according to your daily use.

Why defrosting
Water contained in food or getting into air inside the fridge be opening doors may
form a layer pf frost inside. It will weaken the refrigeration when the frost is thick.
While it is more than 4mm thick, youshould defrost.
Defrosting in frozen-food storage compartment
Defrosting in freezer chamber is operated manually. Before defrosting, take the food
out; take the ice tray and drawers out or put them into the fresh food compartment
temporarily, then set the knob of the temperature regulator to position “0”(where the
compressor will stop working) and leave the door of the refrigerator open until ice and
frost dissolve thoroughly and accumulation at the bottom of the freezer chamber. Wipe
off the water with soft cloth. In the case of speeding up the process of defrosting,
you may put a bowl of warm water (about 50℃) into the freezer chamber, and scrape
away the ice and rost with a defrosting spatula. After doing so, be sure to set the knob
of the temperature regulator to the original position.
It is not advisable to heat the freezer chamber directly with hot water or hair dryer while
defrosting to avoid deformation of the inner case.
It is also not advisable to scrape off ice and frost or separate food from the containers
which have been congealed together with the food with sharp tools or wooden bars, so
as not to damage the inner casing or the surface of the evaporator.
Warning!
Switching off the appliance.
To switch off the appliance, turn the temperature regulator to position ”0”.
Important!
The fridge should be defrosted at least every one month. During the using process, if
the door was opened
frequently or using the appliance in the extreme humidity, we advise the user to defrost
every two weeks .