Hoover HTN7185A User manual

DOUBLE DOOR TOTAL NO FROST EN

DOUBLE DOOR TOTAL NO FROST
CONTROL PANEL
FREEZING
DEFROSTING
Open the top door of the fridge in order to access the control panel.
Turn on the knob to switch on the appliance and set the temperature of the freezer compartment and fridge. We recommend you set the
temperature to 2 or 3. Turn the knob to "0" to turn off the appliance.
The orange light comes on when the thermostat knob is
turned to SUPER. In this case the compressor continues to
function as normal.
The green "ON" light shows that the unit is working. This
light is on irrespective of the knob setting, except for when
the knob is set to 0
Important: Some appliances will start working at least 6 minutes after the plug has been inserted in the power outlet and the temperature
has been set.
(Figure 1)
(Figure 2)
Defrosting of the fridge compartment occurs automatically in
this product.
A small amount of frost or drops of water on the back of the
fridge compartment when the fridge is working is normal.
Make sure the water outlet is always clean. Make sure foods
do not touch the back or sides of the fridge compartment.
N.B. This is the rating plate. If you need to contact our Service Department in the event of faults, remember to give them the
information on the plate.
Important: If the room temperature is very warm, the appliance may work continuously and a layer of frost will deposit
on the back of the fridge compartment. In this case, turn the knob to lower settings (1-2).
2 EN
SUPER ON
1
23
4
SUPER
0
The rating plate states the maximum quantity of food that can be frozen. First of all, create the space necessary to place the load to be frozen on
the bottom shelf of the freezer. After a few hours, place the food to be frozen on the bottom shelf of the freezer and set the thermostat to SUPER.
At the same time, an orange indicator will light up on the panel. Freezing will be completed after 24 hours. (need one blank space) In any case,
after 26 hours, from the SUPER position, the circuit board automatically deactivates the function, turning off the orange light. (need one blank
space) After the freezing process reset the thermostat knob to the recommended settings.

REVERSING THE OPENING OF THE DOORS
Place or tilt the fridge at a 45° angle, since
it is necessary to work on the bottom of the
appliance.
Remove the bottom hinge by removing the
screws, the plug and washers, then remove
the bottom door.
Remove the middle screw and remove the
top door.
Remove the caps (A) and (B), loosen and
remove the screws and partially remove the
panel .
Unscrew the right hinge. Mark and break the left-hand slot on the
panel, in the insert area.
Flip the top left-hand hinge found in the
accessories kit.
Remove the plug on the left-hand side and
insert it on the right hand-side of the central
and lower inserts.
Reassemble the hinges and doors working
from bottom to top 1 2 3.
In order to reverse the opening of the doors, follow the indications in relation to the insert and hinge type your product is made up of.
3 EN
45°
(A) (B)
1
2
3
Bush
Cap
TOTAL NO FROST
The products with total no frost comprise of a ventilation system made up of 2 manually adjustable outlet vents. It is recommended that you
keep the outlet vents partially or completely open.
CLOSED OPEN

Z STUDIO > 05-2008 – Cod. 41027461