HORAGE LENSMAN 1 User manual

LENSMAN 1
USER MANUAL

2
Dear Customer,
Congratulation on your new HORAGE Lensman 1,
we hope it brings you much joy in the years to come.
Please be sure to review the “Important Information” and “Operation Instructions”
Listed below prior to using your Lensman 1.
LENSMAN 1
Movement-K-TOU

Attention: In order to guarantee the reliability of your HORAGE watch, we have created a short list
of recommendations for you.
Your Lensman 1 has a hand-wound movement. This means it must be wound rst before it can
run, and then again before the power reserve is depleted.
• The rst step you should take is to fully wind the movement by turning the crown approximately
40 times in a clockwise direction.
• The energy from winding the watch is stored in the main spring located in the main barrel, and
this reserve of energy is referred to as the power reserve.
• The Lensman 1 has a power reserve of over 5 days, or 120 hours. A fully wound watch will run
longer than 5 days, however, the amplitude or consistency of the energy will reduce after 5
days, and therefore the precision of the watch could be impacted.
IMPORTANT INFORMATION
3
LENSMAN 1
Movement-K-TOU

• The accuracy of the Lensman 1 is calculated within a 5-day operating timeframe and therefore
to ensure your watch remains precise please be sure to wind the watch on or before the 5th
day prior to it last being wound.
• Although our movements utilize a silicon escapement that performs well in everyday magnetic
elds. Strong magnetic forces can negatively impact a mechanical watch’s performance.
We recommend that you keep your Lensman 1 away from magnets, batteries, or devices that
emit strong magnetic elds.
• The Lensman 1 is very reliable; however, as a precision mechanical watch with many moving
parts, impacts such as dropping the watch should be avoided.
To ensure your watch remains water-resistant to the maximum water pressure designated on
the watch case, always return the watch crown to the fully pushed-in position.
Water resistance can be aected over time by impact shocks, chemical reactions with substanc-
es such as gasoline, adhesives, paints, cleaning sprays, etc.
USEFUL INFORMATION
4
LENSMAN 1
Movement-K-TOU

• Excessive, continued turning of the crown can reduce the longevity of seals used for water re-
sistance. If you frequently take your watch in the water, it is recommended to have its water
resistance checked by your local watch service center every three years.
• From time to time, you may feel a desire to clean your watch. Before doing so, please remove
the strap as outlined in the operating instructions.
• Ideally, use a small plastic or rubber bowl and ll it with warm water and some gentle hand-
washing soap. Before placing the watch case in the warm water, be sure to check that the
crown is in the pushed in and closed position.
• Using a soft cotton cloth, you can gently clean the case. Once nished, rinse the case with fresh
water and pat dry with a dry, soft cotton towel. Afterward, bu with a microber hand towel.
USEFUL INFORMATION
5
LENSMAN 1
Movement-K-TOU