Kit Contents
2 x Up & Down Wall Lights
2 x Hardware Kit
4 x Screws
4 x Masonry Plugs
The perfect lighting solution to add a touch of elegance
and sophistication to your outdoor space. With its sleek
design and warm white glow, this light will transform your
home’s exterior into a captivating gallery.
Lighting Modes
The Up & Down Wall Light has 2 modes:
1Low Light
2 High Light
Activate the light
Use the “On/Off” button located on the bottom of the
solar light to turn the lights on. To test the light, hold your
hand over the solar panel and check if the light comes on.
The same button controls the two different lighting modes
and will cycle between, low light, high light, and off.
Product Installation
STEP 1 Find a suitable location
Solar lights need access to direct sunlight for optimum
results; preferably 6-8 hours per day.
STEP 2 Install Solar Light
Product Installation – Option A
Using supplied hardware
A.1 Mark out holes with a marker pen.
A.2 Use a 6mm drill bit for masonry installation to drill the
two holes. Gently hammer the plugs into place and then
secure the screws tightly.
A.3 For timber, drill 3mm pilot holes to guide screws into
place (plastic plugs are not required).
A.4 Be sure to leave some of the screw hanging out as the
light hangs like a picture.
Product Installation – Option B
Using adhesive outdoor tape
B.1 Adhere using Hoselink Outdoor Acrylic Double-Sided
Tape (SKU L100), sold separately. Stick the tape onto the
back of the light then adhere to a clean, dry surface.
Specifications
WARNING: Do not use this light underwater
or in low-lying puddles.
Solar panel Monocrystalline Silicon
Lithium battery 3.7V / 1200mAh
Operating time Low 10 hours, High 6 hours
Charge time 6 hours
Light temperature (Kelvins) 2800 - 3200K
LED lumens Low 35, High 43
Number of LEDs 4
