HoverCam Pillar 695 User manual

Mobile Convertible Stand
Pillar 695
For support please contact: [email protected] | 866-201-2056

ASSEMBLY INSTRUCTIONS
2 PERSON ASSEMBLY TOOLS AND HARDWARE
REQUIRED
REMOTE CONTROL
OPERATION
BASE PLATE
WITH CASTERS
POWER CABLES
MOTORIZED PILLAR
ASSEMBLIES
BACK PLATE
ASSEMBLY

STAND ASSEMBLY
1.Place the base plate on a flat, level surface.
Lock the wheels to prevent movement.
2.Connect power from the base plate to the
motorized height adjustable pillars as shown
below.
3.Align and dock the motorized height
adjustable pillars and the base plate.
4. Use 8 M5 screws to securely bolt the two
assemblies together
5. Use 12 M5 screws to securely attach
the back plate assembly to the height
adjustable pillars. Six screws on each side
as shown below.
4x
6x

RANGE OF MOTION
BACK PLATE INSTALLATION
Max range ~13.8"
90° Tilt
6.Connect power to the back plate tilt
mechanism by making the connections as
shown below

STAND OPERATION
Elevator motor
Elevator motor
Tilt motor
AC Outlet (AC100-240V)
AC In (AC100-240V)
Down button
Up button
Tilt up button
Tilt down button
① ② ③
④
⑤
⑥
⑦
⑧
⑨
①
②
③
⑥
⑦
⑧
⑨
④
⑤

Supports panel sizes from 65" to 86"
SUPPORTS LARGE SIZE PANELS

For service and support, please submit a service ticket at the HoverCam
Support center https://thehovercam.desk.com/customer/portal/emails/new
SERVICE & SUPPORT
For support please contact:
HoverCam.com | 866-201-2056
www.thehovercam.com