IFM CR3170 User manual
Quick reference guide
4G/WLAN router
CR3170
11408558 / 0009 / 2021
GB
4G/WLAN router CR3170
3
1 Connections and indicators
Front:
Status LEDs LAN
LAN Ethernet ports
WAN Ethernet port
RS485 interface
Status LED WAN
LED for strength of mobile radio
signal
Status LED for mobile radio
connection
Connector for inputs / outputs
RS232 interface
Connector for power supply
Status LED for power supply
Fig.1: Front
Rear:
AUX connector for mobile
radio antenna
SIM card holder 1
Connector for
GPS antenna
SIM card holder 2
Connector for WLAN antenna
Reset key [R]
USB interface
SIM needle
Main connector for mobile radio
antenna
Fig.2: Rear
Cable for power supply (PWR), wire colours:
• VBBS: red
• GND: black
• Input: green
• Output: white
CR3170 4G/WLAN router
4
2 Set-up
There is already an activated SIM card in the unit (in SIM card holder 1).
uConnect all required antennas.
uConnect the supply voltage and switch on.
uConnect to the unit via
WLAN (SSID and password can be found on the product label)
OR
Ethernet cable and LAN Ethernet port
uEnter http://192.168.82.1 in the browser to open the web interface of the unit.
uLog in with the following data in the login window:
- Username: admin
- Password: admin01
and click [Login].
uAfter logging in, change the password. The new password must contain at least 8 characters,
including at least one upper case letter, one lower case letter and one number.
If the password is not changed, the further steps are not possible.
wAfter successfully changing the password, the configuration wizard will start.
The basic operating parameters can be set in the configuration wizard.
uOpen the overview page and observe the signal strength display.
To optimise reception, align the antennas accordingly and, if necessary, position the unit differently.
Further information at https://wiki.teltonika-networks.com/view/RUT955
Technical data also at www.ifm.com
