ikbc typemaster X400 User manual

typemaster X400
®
User Manual

typemaster X400
®
Product Introduction
Package Contents
1. Keyboard x1
2. User manual x1
3. Key puller x1
4. USB Type C cable x1
5. ESC keycap x1
The Typemaster is with QWERTY layout, the layout is 87 KEYS, X400 is equipped
with MX Low Profile RGB switch. X400 is with Type-C connector so the connector
is stronger than before. It’s supporting N-key Roll Over and Dual PCB board and
LED backlit X400 is with a passwork lock function on the keyboard, the lock
function is protected this keyboard.

Keyboard Specification:
Function Description:
Key Feature:
Key number: US ASCII (87 keys) = US Layout
Key switch lifetime: 50KK Times
Dimensions: L 347.5mm、W 146mm、H 28.62mm
Interface: USB（DC5V ---- 500mA）
Cable length: 1.8 m
Switch the main switch to the left (red) to lock the keyboard, and turn to the
right (green) in order to unlock the keyboard.
The shortcut functions can be accessed through pressing Fn+(F1-F12).
When is pressed, F1-F12 will automatically activates below function.
Rotate counter-clockwise to decrease the volume, and rotate the button
clockwise to increase the volume. Press down the button to switch to silent
and non-silent mode.
Button
Function
Key Shortcut Function
Turn on/off Backlit
Change Backlit Mode
Decrease Backlit Brightness
Increase Backlit Brightness
Change direction of Backlit
Change back direction of Backlit
Decrease the backlit flashing rate
Increase the backlit flashing rate
Play/pause playlist
Previous Song on playlist
Next Song on playlist
Calculator Application
F1
F2
F3
F4
F5
F6
F7
F8
F9
F10
F11
F12
Password
Setup
Password
Reset/update
F-Section Short
Cut Key Lock Win Key Lock Reset all Settings

Password Protection Function:
Password Setup:
Keyboard locking feature will be activated when the switch is turned to the
left, when keyboard is locked, the keyboard will not be able to provide any service.
When is switched to the right, the keyboard is activated and ready to use.
A passcode can be set up to activate and deactivate the keyboard as well.
1. Make sure the keyboard is turned on.
2. Press button.
3. Create a passcode between 1-6 digit when the number key caps are lit up, then
press enter to confirm the passcode.
4. Password is set up completely after all the steps above have been completed.
**Please Note:
1. When the password is entered incorrectly, you may re-enter the correct password
again after keypads have done flashing.
2. If the password is entered incorrectly 3 times, it will go back to the first step of
initial password setup.
3. Password setup will end if is pressed during the setup.
4. To cancel entering the password login, just simply press the “enter” key on the
keyboard.
5. The password will not be wiped out even when the keyboard is disconnected
from the power.
Please enter the correct password when the keyboard is first turned on from the
off mode (number keypad will be flashing to remind you) to unlock the keyboard.
If the password is entered incorrectly for 7 times, the keyboard will lock itself up.

Change Password:
Backlit Feature:
Reset to Manufacturer Setting:
**Please Note:
1. If the password is entered incorrectly 3 times during the password reset
process, the password reset will fail.
2. When the keyboard is locked due to entering the incorrect password for too
many times, you may use a tool with sharp tip to poke the hole on the bottom
of keyboard by the stand to erase the password.
With no password implemented: Press button for 5 seconds, when all the
keys flash 3 times and go off, the keyboard will reset back to its manufacturer
setting.
With password implemented: Press button for 5 seconds then enter the
correct password afterward, and the keyboard will reset itself.
provides and supports 7 types of backlit which includes:
Solid, Breathing, Single Color, Reactive, Wave, Ripple, Lightening modes.
Please use Fn+F2 key to adjust the backlit modes.
1. Please make sure keyboard is turned on.
2. Press Key.
3. Enter the original password when the number pad is flashing, then press “enter”
key to confirm.
4. Press key when it is lit up after entering the correct original password,
then you can reset the new 1-6 digits new password.
5. If the password is entered incorrectly, you may re-enter the password after the
keypads flashed. However, if the password is entered incorrectly for 7 times,
the keyboard will lock itself up.
typemaster X400
®