IKEA KULINARISK User manual

KULINARISK
GB
FR
DE
IT

ENGLISH 4
DEUTSCH 14
FRANÇAIS 27
ITALIANO 40
Please refer to the last page
of this manual for the full list
of IKEA appointed Authorized
Service Centre and relative
national phone numbers.
Gehen Sie dazu auf die letzte
Seite dieser Broschüre. Dort
nden Sie eine Übersicht mit den
entsprechenden Telefonnummern
und Kontaktdaten unserer
autorisierten Kundendienste.
Consultez la dernière page de ce
manuel pour la liste complète des
centre d’entretien et de réparation
agréés IKEA avec leur numéro de
téléphone respectifs.
Siete pregati di contattare il
numero del Centro Assistenza
Autorizzato incaricato da IKEA
riportato sull’ultima pagina di
questo manuale.

ENGLISH 4
Beforerstuse
Your safety and that of others is paramount.
Remove cardboard protection pieces,
protective lm and adhesive labels from
accessories.
Check the appliance for any transport
damage.
To avoid any damage do not place any
weights on the appliance. Do not expose
the appliance to atmospheric agents.
This manual and the appliance itself provide
important safety warnings, to be read and
observed at all times.
This is the attention symbol, pertaining
to safety, which alerts users to potential
risks to themselves and others.
All safety warnings are preceded by the
attention symbol and the following terms:
DANGER: indicates a hazardous
situation which, if not avoided, will
cause serious injury.
WARNING: Indicates a hazardous
situation which, if not avoided, could
cause serious injury.
All safety warnings give specic details
of the potential danger/warning present
and indicate how to reduce risk of injury,
damage and electric shock resulting from
improper use of the appliance. Carefully
observe the following instructions.
Precautionsandgeneral
recommendations
• The electrical installation and the
electrical connection must be carried
out by a qualied technician according
to the manufacturer’s instructions and
in compliance with the local safety
regulations. Do not repair or replace any
part of the appliance unless specically
stated in the user manual.
• The appliance must be disconnected
from the power supply before carrying
out any installation work.
• Earthing of the appliance is compulsory.
(required only for class I).
• The power cable must be long enough
for connecting the appliance, once
tted in its housing, to the power supply
socket.
• Do not pull the power supply cable in
order to unplug the appliance.
• The electrical components must not be
accessible to the user after installation.
• Do not touch the appliance with any wet
part of the body and do not operate it
when barefoot.
• The appliance is not intended for use
by persons (including children) with any
physical, sensory or mental impairment,
or without experience and knowledge
of the appliance, unless supervised or
previously instructed in its use by those
responsible for their safety.
• Do not repair or replace any part of the
appliance unless specically indicated
in the manual. All other maintenance
services must be carried out by a
specialised technician.
• Children must be supervised to ensure
they do not play with the appliance.
• When drilling through the wall pay
attention not to damage electric
connections and/or pipes.
• Air vents must always discharge to the
outside.
Safetyinformation 4
Productdescription 7
Controlpanel 8
Cleaningandmaintenance 9
Whattodoif... 11
Technicaldata 12
Environmentalconcerns 13
SafetyInformation
Contents

ENGLISH 5
• The manufacturer rejects all
responsibilities for any damage caused
by improper use or wrong settings.
• Appropriate maintenance and cleaning
ensure the good working order and
the best performance of the appliance.
Regularly clean all stubborn surface dirt
to avoid grease build up. Remove and
clean or change the lter regularly.
• Never ame cook food (ambé) under
the appliance. Using free ames might
cause re.
• Failure to observe the instructions for
cleaning the hood and replacing the
lters may result in a re.
• Exhaust air must not be vented through
a ue used for removal of fumes
produced by gas combustion appliances
or other combustible materials, but must
have a separate outlet. All national
regulations governing extraction of
fumes must be observed.
• There shall be adequate ventilation if
the hood is being used at the same time
as other appliances using gas or other
combustible materials. The negative
pressure of the room must not exceed 4
Pa (4x 10-5 bars). For this reason ensure
that the room is well ventilated.
• Do not leave frying pans unattended
when frying, as the frying oil may catch
re.
• Before touching the light bulbs, ensure
that they are cold.
• Do not use or leave the hood without
the light bulb correctly tted, as this may
cause electric shock.
• The hood is not a work surface, therefore
do not place any objects on top of it or
overload it.
• During all installation and maintenance
operations wear appropriate working
gloves.
• This appliance is not suitable for outdoor
use.
WARNING: when the hob is in use,
accessible parts of the hood may
become hot.
Installationandconnection
After unpacking the appliance, check for
any transport damage. In the event of
problems, contact the Authorized Service
Centre. To prevent any damage, only
remove the appliance from its polystyrene
foam packaging at the time of installation.
Preparingforinstallation
WARNING: this is a heavy product; the
hood should only be lifted and
installed by two or more people.
The minimum distance between the hob and
the bottom part of the hood must not be less
than 65 cm for burning gas or other fuels
and 50cm for electric cookers.
Before installation also check the minimum
distances stated in the manual of the cooker.
If the installation instructions for the cooker
specify a greater distance between cooker
and hood, this distance must be observed.
Electricalconnection
Make sure the power voltage specied on
the appliance rating plate is the same as
the mains voltage.
This information can be found on the inside
of the hood, under the grease lter. Power
cable replacement (type H05 VV-F) must
be carried out by a qualied electrician.
Contact an authorized service centre.
If the hood is tted with an electric plug,
connect the plug to a socket complying with
current regulations, located in an accessible
place.
If no plug is tted (direct wiring to the
mains), or if the socket is not located in an
accessible place, a qualied electrician
should install a standardised double pole
power switch that will enable complete
isolation from the mains in case of category
III overvoltage conditions, in accordance
with wiring rules.

ENGLISH 6
Use
The hood has been designed to be installed
and used either as a “Exhausted model”, or
as a “Recirculation model”.
Exhaustedmodel(seesymbol in
installationbooklet)
Cooking steam is sucked and channelled
outside the house through a discharge duct
(not supplied), tted to the hood steam
outlet.
Ensure that the discharge duct is correctly
tted to the air outlet, unit using an
appropriate connection system.
Important:If already installed, remove the
charcoal lter/s.
Recirculationmodel(seesymbol in
installationbooklet)
The air is ltered through one or more the
charcoal lters, and then resent into room.
Important:Ensure appropriate air
circulation around the hood.
Important:If the hood is supplied without
charcoal lters, these must be tted before
the hood can be used. Filters are available
in shops.
The hood should be installed away from
particularly dirty areas, windows, doors and
heat sources.
The accessories for wall xing are not
included because walls made of different
materials require different types of xing
accessories. Use xing systems suitable for
the walls of your home and the weight of
the appliance. For more details, contact a
specialized dealer.
Keep this booklet for future consultation.

ENGLISH 7
Productdescription
4
1
2
3
1 Chimney.
2 Control Panel.
3
4 Grease lter.
Light.

ENGLISH 8
Controlpanel
Operation
Use the fastest speed setting for particularly
concentrated steam and fumes. It is
advisable to switch the hood on 5 minutes
before starting to cook and leave it running
for another 15 minutes at the end of
cooking.
To select the hood functions simply touch the
controls lightly.
A - MOTOR OFF button (stand-by)
Press briey to turn the motor off.
- ELECTRONICS ON/OFF
Press for 3 seconds to disable the hood
control electronics. This function may
be useful when cleaning the product.
To turn the electronics back on again,
simply repeat the operation. In case of
malfunctioning, before contacting the
Authorized service center disconnect the
hood from the mains supply by pulling
the plug out for at least 5 seconds, then
re-connect. If the fault persists, contact
an Authorized service center.
B Low speed (extraction power) selection
button.
When the light ashes, wash the grease
lter
C Medium speed (extraction power)
selection button
When the light ashes, wash or replace
the charcoal lter.
D High speed (extraction power) selection
button
E Intensive speed (extraction power)
selection button
After 5 minutes the intensive speed is
automatically going back to preview
speed.
If needed press again to return to the
previous setting.
F Light ON/OFF button
A B C D E F

ENGLISH 9
WARNING:- Never use steam
cleaning equipment.
- Disconnect the appliance from the power
supply.
IMPORTANT: do not use corrosive or
abrasive detergents. If any of these products
accidentally comes into contact with the
appliance, clean immediately with a damp
cloth.
• Clean the surfaces with a damp cloth.
If it is very dirty, add a few drops of
washing up detergent to the water.
Finish off with a dry cloth.
IMPORTANT: do not use abrasive sponges
or metallic scrapers or scourers. Over time,
these can ruin the surface.
• Use detergents specically designed for
cleaning the appliance and follow the
manufacturer instructions.
IMPORTANT: clean the lters at least
monthly to remove any oil or grease
residuals.
Tocleanthegreaselter
The metal grease lter has an unlimited life
and must be washed once a month by hand
or dishwasher at low temperature and with
a short cycle. With cleaning in a dishwasher
the grease lter may become dull; this does
not effect its ltering capacity.
Greaseltermaintenance:
1. Disconnect the hood from the electric
power supply.
2 Remove the grease lters: pull the spring
release handle downwards, then remove
the lter.
3. After cleaning the grease lter, remount
in reverse order ensuring the entire
extraction surface is covered.
Cleaningandmaintenance

ENGLISH 10
Charcoalltermaintenance(ifthehoodis
installedinrecirculationmode)
1. Unplug the appliance or disconnect the
power supply.
2. Remove the grease lter
3. Remove charcoal lter holder
4. Remove/add charcoal lter
5. Fix metal wire to keep the charcoal lter
in the correct position
6. Hook the carbon lter rstly to the metal
tab at the back on the hood.
7. Fix it at the front with the two knobs.
8. Ret the grease lter.
Unlike traditional charcoal lters, this
charcoal lter can be washed and
reactivated.
With normal hood use, the lter should
be cleaned once a month. The best way
to clean the lter is in a dishwasher at
the highest temperature possible, using
a normal dishwasher detergent. To avoid
particles of food or dirt settling on the
lter during washing and giving rise to
unpleasant smells, it is advisable to wash
the  lter on its own. After washing, dry the
lter in the oven at 100°C for 10 minutes to
reactivate it.The lter will retain its odour-
absorbing capacity for three years, after
which it will have to be replaced.
Filterwarninglightreset
After lter maintenance, press the button for
3 seconds; the ashing button B (grease
lter) or C (carbon lter) will stop ashing.
This light is usually disabled, to enable press
buttons B and C together, rst only button
B will ash, then both buttons B and C
will ash to indicate that the function has
been enabled. Repeat the operation to
disable the function; rst both buttons B
and C will ash, and then only button B
will ash to indicate that the function has
been disabled.
Lampmaintenance
The hood is equipped with a lighting system
based on LED technology.
The LEDs guarantee an optimum lighting,
a duration up to 10 times as long as the
traditional lamps and allow to save 90%
electrical energy.
For replacement, contact the Authorized
Service Centre.