In studio Milan User manual

Milan – Touch Micro System

Important Safety Instructions
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with a dry cloth.
7. Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators,
heat registers, stoves, or other apparatus (including
amplifiers) that produce heat.
9. Do not defeat the safety purpose of the polarized or
grounding-type plug. A polarized plug has two blades with
one wider than the other. A grounding type plug has two
blades and a third grounding prong. The wide blade or the
third prong is provided for your safety. If the provided plug
does not fit into your outlet, consult an electrician for
replacement of the obsolete outlet.
10. Protect the power cord from being walked on or pinched
particularly at plugs, convenience receptacles, and the
point where they exit from the apparatus.
11. Only use attachments/accessories specified by the
manufacturer.
12. Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer, or
sold with the product. When a cart is used,
use caution when moving the cart/product
combination to avoid injury from tip-over.
13. Unplug this product during lightning storms or when
unused for long periods of time.
14. Refer all servicing to qualified service personnel. Servicing
is required when the product has been damaged in any
way, such as power-supply cord or plug is damaged, liquid
has been spilled or objects have fallen into the product,
the product has been exposed to rain or moisture, does
not operate normally, or has been dropped.
15. This product shall not be exposed to dripping or splashing
water and that no object filled with liquids such as vases
shall be placed on the product.
16.
Rating label and caution mark are located at the bottom of
product.
To ensure safe, appropriate use of your personal CD player, please follow the advice below.
CLASS 1 LASER PRODUCT
CAUTION
INVISIBLE LASER RADIATION WHEN UNIT IS OPENED
AND INTERLOCKS ARE DEFEATED. AVOID EXPOSURE
TO LASER BEAM.
This product contains a
low power laser device.

Enter button (ENTER)
backwards
forwards
Memory/Clock button (MEMORY/CLOCK)
Open/Close CD door button (OPEN/CLOSE)
(DBBS)
20. Stereo/Mono/ID3/ESP display button (STEREO/MONO/
ID3/ESP)
EQ EQ
OPEN/CLOSE button ( )
Preset up button(PRE +)
Preset down button(PRE -)
/MENU /MENU
1
3 5 7 9 10 12 14
2 4 6 8 11 13 15
Speaker
Volume down button
15.
16.
17. USB port (USB)
18. AUX IN jack (AUX IN)
19.DC input
20. FM antenna jack
21. Remote sensor
Volume up button
17 16 18
Top panel
19 20
21
dock

Press the MEMORY/CLOCK button for at least 2 seconds.
The number 12 will flash in “12 HOUR” format. Press the
to set 24 hour mode.
6.
AUX IN USB
unit or
to confirm
to confirm
current time is displayed.
The clock can be synchronized automatically when inserting the
The clock will be in 12 hour mode by default. If you want to set
24 hour mode, please change the hour mode during clock setting
in STANDBY mode.
iPhone/iPod at the first time after 60 seconds. It can also be set later
by pressing and holding the MEMORY/CLOCK button in iPod mode
with an iPhone/iPod docked when a time signal is received after
60 seconds.
plug
DC connector
dims
“DBBS”
DBBS

Pause play
(Remote control only)
EQ
READING
CD the tray,
tray.
READING
button
button
“ALBUM”
unit or
power cord.
power cord in
forward
backward
CD
FLAT

port
This unit supports files whose names have the extension letters,
“.MP3” or “.mp3”/”.WMA” or “.wma”.
at
ing depending
on

DISC/USB Drive
track
or dock a USB drive READING
/ESP
/ESP
/ESP
/ESP
/ESP
CD
CD MEMORY
CD MEMORY
CD
CD
CD
CD MEMORY
CD MEMORY
CD MEMORY
ing may sometimes happen
depending on
character

/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
/iPhone
NOTE: To stop the playback, only press the button on the iPod/iPhone,
not on the unit.
The iPod/iPhone will be charged when the unit is powered on. It will
stop charging if the unit is set to Standby.
This unit operates with the below iPod/iPhone models:
Note:
Apple is not responsible for the operation of this device or its compliance with safety
and regulatory standards.
Please note that the use of this accessory with iPod or iPhone may affect wireless
performance.
4

AUX
2
TUNER
TUNER MEMORY
TUNER MEMORY
TUNER
05
/ESP
/ESP
AUX IN

120, 90, 60, 30 and 15
5
ON TIME
for 2 seconds
OFF TIME for 2 seconds
TUNER
USB iPod
OFF
Alarm
alarm
normal.
but is not
cancelled
cancel

The FCC Wants You To Know
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates, uses, and can radiate radio frequency energy and,
if not installed or used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures: 1) reorient or relocate the receiving antenna; 2) increase the
separation between the equipment and the receiver; 3) connect the equipment to
an outlet on a circuit different from that to which the receiver is connected;
4) consult the dealer or an experienced radio/TV technician for additional
suggestions.
for compliance could void the user’s authority to operate the equipment. Where
installation of the product, they must be used in order to ensure compliance with
FCC regulation.
Industry Canada-ICES-003
CAUTION
To comply with the limits for a Class B digital device, pursuant to Part 15 of the
comply with the Class B limits.
This Class B digital apparatus complies with Canadian ICES-003.
THE SOURCE WARRANTY
The Source warrants that this product will be free from defects in
materials and workmanship for a period of one (1) year from the date
of purchase. Within this period, simply take the product and your proof
of purchase to any The Source store or dealer and the product will be
repaired without charge for parts and labour. The Source reserves the
right to charge for transportation. Any product which has been subject
to misuse or accidental damage is excluded from this warranty.
This warranty is only applicable to a product purchased through The
Source company owned stores and dealers and to a product that is
presented for repair in a country where The Source offers the product
for sale. While this warranty does not confer any legal rights other than
those set out above, you may have additional statutory rights which will
vary under the laws of the various countries, states, province and other
governmental entities in which The Source operates. This warranty is
subject to all statutory rights you may have in the country of purchase.
LIMITED WARRANTY
Limited Warranty
© 2011 The Source.
All Rights Reserved.
Imported by:
The Source,
Barrie, Ontario, Canada, L4M 4W5
Manufactured in China
For product support please visit
www.thesource.ca
Please Recycle
Recyclez