Indesit IZ A1.UK 1 User manual

EN
Quick guide
THANK YOU FOR BUYING AN INDESIT PRODUCT
In order to receive a more complete assistance, please
register your product on www.indesit.com/register
Before using the appliance carefully read the Safety
Instruction.
FIRST TIME USE
Wait at least two hours, after the installation, before connecting the
appliance to the power supply.
Connect the appliance to the power supply and turn the thermostat
knob to switch on the appliance.
After turning the appliance on, you must wait for 4-6 hours for the
correct storage temperature to be reached for a normally lled
appliance. Position the antibacterial anti-odour lter in the fan as
demonstrated in the lter packaging (if available).
CONTROL PANEL
1. Temperature control lamp (Red Alarm
light)
2. Operation Control lamp (Green light)
3. Open door alarm switch
4. Temperature control knob (thermostat)
1. 2. 3. 4.
TEMPERATURE & OPERATION CONTROL LAMP (GREEN & RED
LIGHT)
Please check that the voltage indicated on the rating plate situated
inside the compartment corresponds to the voltage in your home. The
earthing of this appliace is compulsory by law. The manufacturer will
accept no liability for injury to persons or damage to objects arising
from the non observance of this requirement.
When the appliance is plugged in, if the thermostat knob is not set to
symbol •, the green and the red lamps (points 1 and 2 control panel)
light up. The green control light always remains alight and indicates
the operation of the appliance. The red control light remains alight
until the set operation temperature has been attained. It lights up
again when the temperature inside the freezer rises due to frequent
or prolonged door opening, and when the appliance has been loaded
with fresh food to be frozen.
OPEN DOOR ALARM SWITCH
This appliance is equipped with an acoustic alarm which sounds when
the door is left open.
TEMPERATURE CONTROL KNOB (THERMOSTAT)
The thermostat controls the temperature inside the appliance.
Position •indicates that the operation of appliance is interrupted.
In normal ambient conditions (temperature between +20°C and +25°C),
we suggest you adjust the thermostat control knob to a middle
position. To obtain colder or warmer temperatures than -18°C, turn the
thermostat control knob to the highest or lowest setting respectively.
We remind you that internal temperatures are aected by the location
of the appliance, the temperature of the surrounding air, the frequency
of the door opening. The setting of the thermostat may have to be
varied to allow for these factors. To check the temperature of the food
stored, place the thermometer (if delivered) under the food; if it is
placed on the food
it will indicate the temperature of the air which does not correspond to
that of the food stored.
Recommended setting:
Refrigerator compartment: MEDIUM
To avoid food waste, please refer to the recommended setting and storage
times found in the online user manual.
HOW TO STORE FRESH FOOD
Legend
FREEZER DRAWERS
FREEZING ZONE DRAWER
(Max cool zone)
Suggested to freeze fresh/cooked food
* Available only on certain models

FREEZER COMPARTMENT
Freezing fresh food
1. It is advisable to set the temperature colder or turn on the Fast Freeze/
Fast Cool* at least four hours before removing the food from the
freezer compartment, to prolong the preservation of the food during
the defrosting phase.
2. To defrost, unplug the appliance and remove the drawers. Leave
the door open to allow the frost to melt. To prevent the water from
escaping during the defrost, it is advised that you place an absorbent
cloth on the bottom of the freezer compartment and wring it out
regularly.
3. Clean the inside of the freezer compartment and dry it carefully.
4. Turn the appliance back on and put the food back inside. To remove
the frost on the STOP FROST* accessory, follow the CLEANING.
Ice cubes*
Fill 2/3 of the ice tray with water and put it back in the freezer
compartment. Do not, under any circumstances, use sharp or pointed
objects to remove the ice.
The quantity of fresh food that can be frozen in a specic time period is
indicated on the rating plate.
Load limits are determined by baskets, aps, drawers, shelves etc. Make
sure that these components can still close easily after loading.
Light system (depending on model)
This product contains a light source of energy
eciency class G
This product contains 4 lateral light sources of
energy eciency class A
This product contains a light source of energy
eciency class G
This product contains 4 lateral light sources of
energy eciency class A and a top light source
of energy class G
This product contains a top light source of
energy eciency class G
GENERAL INFORMATION
The drawers, baskets and shelves should be kept in their current position
unless otherwise specied in this quick guide. The light system inside the
refrigerator compartment uses LED lights, allowing for better lighting than
with traditional light bulbs, as well as for very low energy consumption.
Doors and lids of the refrigeration appliance should be removed before
disposal in the landll, to avoid children or animals getting trapped inside.
* Available only on certain models

400011502475
Policies, standard documentation and additional product information can be found by:
• Visiting our website docs.indesit.eu
• Using QR Code
• Alternatively, contact our After-sales Service (See phone number in the warranty booklet). When
contacting our After-sales Service, please state the codes provided on your product's identication plate.
The model information can be retrieved using the QR-Code indicated on the energy label. The label also includes
the model identier that can be used to consult the https://eprel.ec.europa.eu database portal.
TROUBLESHOOTING
What to do if... Possible reasons Solutions
The appliance doesn’t work. There may be an appliance power
supply problem.
Make sure:
• there is not a power failure;
• the plug is properly inserted in the power socket and the double-
pole switch (if present) is in the correct position (on);
• the household electrical system protection devices function;
• the power cable is not broken;
• the thermostat knob is not turned to “•”.
The inside light does not
work.
It may be necessary to replace the light
bulb.
Disconnect the appliance from the power supply and contact the
Technical Assistance Service if you need a replacement.
The internal temperature
of the compartments is not
cold enough.
The reasons could vary (see “Solution”)
column.
Check that:
• the doors are closed properly;
• the appliance is not installed near a heat source;
• the temperature is appropriately set;
• the circulation of air through the ventilation grilles on the base of
the appliance is not obstructed.
The appliance is excessively
noisy.
The appliance has not been installed
correctly.
Check that the appliance is level.
Excessive amount of frost in
the freezer compartment.
The door to the freezer compartment is
not closed properly.
• Check that there is nothing preventing the door from closing
properly.
• Defrost the freezer compartment.
• Make sure the appliance has been correctly installed.
The front edge of the
appliance that the door
gaskets seal against is hot.
This is not a problem. It prevents
condensation from forming.
A solution is not needed.
If the red light is on
continuously or ashing, the
internal temperature is too
high.
The appliance has not been installed
correctly.
Check that:
• the door is not properly shut;
• the thermostat control knob is correctly set (see chapter
“Adjustment of the temperature”);
• the freezer is not near a source of heat;
• there is a large build up of frost on the inner walls;
• the air ow is not restricted.
* Available only on certain models