Interconnective Partner Installation guide

Basic Manual

What do all the buttons do?

Interface Introduction
1. 2. 3. 4. 5.
6.
7.
8.
9.
1. Current Resolution/ Frames per Second
2. Wifi Connected (For Wifi Capable Models)
3. 4G Connected (For 4G Capable Models)
4. GPS Activate
5. Battery Life Indicator
6. Current Pre-Record Settings
7. Product/Officer ID
8. Available/ Total Memory
9. Date and Time

Basic Operation
Before Starting Patrol:
1. Make sure the battery has been charged and/or you have a
spare battery with you.
2. Make sure that you have enough available memory and that
your previous patrol has been download and removed from the
camera.
3. Before setting out, ensure that the camera has been turned on
before you set out. When on but not recording, the camera will
be in standby mode.
On Patrol:
1. When you want to begin recording video, press the button on
the top left of the camera. When you want to end the recording,
press the same button.
2. When you need to take a snapshot, simply press the button on
the top right of the camera.
3. If you want to check if you are recording or if the device is on,
pay attention to the LED lights in the center of the top of the
camera. Green means in stand-by mode, Red means recording
video.

Interconnective Ltd
Lower Ground Floor Priory Gate House
7 Priory Road, High Wycombe
Buckinghamshire
HP13 6SE
[phone]
[e-mail]