inuvi GPS-306 User manual
inuvi - Protecting Your Life!
inuvi GPS-306 3G Quick Installation Guide
inuvi GPS-306 3G Tracker Preparation
● Insert a nano-SIM card with chip facing downward (For Hong Kong based users CSL
prepaid card suggested) into the nano-SIM card slot.
● Make sure that the SIM’s PIN code is deactivated. For CSL Hong Kong the PIN code
is deactivated by default.
● Make sure the tracker has a minimum battery charge. Use a micro USB cable to
charge the device for about 20 to 30 minutes. The charging port is next to the
nano-SIM card slot. Use a standard USB phone charger or a computer USB port.
inuvi GPS-306 3G Tracker 4-Step Setup SMS Commands
1. Step 1: Set server IP and Port for the inuvi tracking server
SMS Command: adminip123456 16.163.78.37 40265
Reply from device: adminip ok
2. Step 2: Set phone number for SMS alerts
SMS Command: admin123456 00000000 (00000000 = phone number)
Reply from device: admin ok!
3. Step 3: Turn tracker’s GPRS on
SMS Command: gprs123456
Reply from device: GPRS ok!
4. Step 4: Arm the device! If not done, no data will be sent to the server!
SMS Command: arm123456
Reply from device: Tracker is activated
Revision: 27072022_CHL_V4
inuvi - Protecting Your Life!
Optional SMS Commands
1. Check tracker status
SMS Command: check123456
Reply from device: (Various readings)
2. Change tracker admin password
SMS Command: password123456 000000 (“000000” = new password with 6 digits)
Reply from device: password ok!
3. Set tracking distance (recommended)
SMS Command: distance000000 0010 (“000000” = current password)
Reply from device: distance ok!
4. Set tracker sensitivity (recommended)
SMS Command: sensitivity000000 2 (“000000” = current password)
Reply from device: sensitivity ok
5. Check tracker IMEI
SMS Command: imei000000 (“000000” = current password)
Reply from device: XXXXXXXXXXXXXXX (15 digits)
6. Set tracker time zone
SMS Command: time zone000000 8 ("000000" replace with your actual password.
"8" = GMT +8 for Hong Kong for example. Set based on your location’s offset from
GMT!)
Reply from device: time OK
Command format: “time+space+zone+password+space+time”
Revision: 27072022_CHL_V4
inuvi - Protecting Your Life!
inuvi GPS-306 3G Tracker Final Installation Step
Install the tracker into the vehicle's OBD-II port usually located near to the steering wheel
in the interior of the vehicle. Make sure that the tracker is turned ON before you insert it
into the OBD-II socket!
Note: The tracker's IMEI number needs to be activated on the inuvi tracking server. Please
get in touch with inuvi service team to assist with tracker activation. You need to provide the
trackers IMEI number (refer to point 5, section “Optional”).
support ticket request.
Revision: 27072022_CHL_V4
Table of contents
Other inuvi GPS manuals
