inuvi P-905 3G User manual

inuvi - Protecting Your Life!
inuvi P-905 3G Quick Installation Guide
inuvi P-905 3G Tracker Preparation
● Insert a SIM card with chip facing upward (For Hong Kong based users CSL prepaid
card suggested) into the SIM card slot. Use the supplied SIM card adapter if needed.
● Make sure that the SIM’s PIN code is deactivated. For CSL Hong Kong the PIN code
is deactivated by default.
● Make sure the tracker has a minimum battery charge. Use a micro USB cable to
charge the device for about 20 to 30 minutes. The charging port is next to the SIM
card slot. Use a standard USB phone charger or a computer USB port.
inuvi P-905 3G Tracker 4-Step Setup SMS Commands
1. Step 1: Set server IP and Port for the inuvi tracking server
SMS Command: adminip123456 52.36.52.133 40265
Reply from device: adminip ok
2. Step 2: Set device to tracking mode (Tracker activation)
SMS Command: tracker123456
Reply from device: tracker ok
3. Step 3: Turn ON GPRS
SMS Command: gprs123456
Reply from device: gprs ok
4. Step 4: Set data upload interval
SMS Command: upload123456 10
Reply from device: upload ok
Revision: 14022020_CHL_V3

inuvi - Protecting Your Life!
Optional SMS Commands
1. Check tracker status, battery status, ID and location)
SMS Command: G123456#
Reply from device: (Various readings, including IMEI ID)
2. Change tracker admin password
SMS Command: password123456 000000 (“000000” = new password with 6 digits)
Reply from device: password ok
3. Set admin phone number (The number allowed to make configuration changes)
SMS Command: admin000000 xxxxxxxx (“000000” = password, “xxxxxxxx” = phone
number to send SMS commands to the tracker, usually your phone number)
Reply from device: admin ok
4. Set tracker speed alarm in km/h
SMS Command: speed000000 090 (“000000” = password, “090” = speed limit)
Reply from device: speed ok
Cancel speed alarm with SMS command: nospeed000000
5. Activate shock alarm
SMS Command: shock000000 (“000000” = password)
Reply from device: shock ok
Cancel shock alarm with SMS command: noshock000000
6. Set correct time zone in reference to GMT
SMS Command: timezone000000 +8 (in this example: Hong Kong time)
Reply from device: time ok
7. Reset the device back to default
SMS Command: begin000000 (“000000” = password)
Reply from device: begin ok
Revision: 14022020_CHL_V3

inuvi - Protecting Your Life!
inuvi P-905 3G Tracker Final Installation Step
Place the tracker inside your car or elsewhere.Make sure that the SIM card is inserted
correctly and that the tracker is fully charged. The tracker will turn on automatically once the
SIM card is inserted and will turn off automatically once the card is removed from the tracker.
Note: The tracker's IMEI number needs to be activated on the inuvi tracking server. Please
get in touch with inuvi service team to assist with tracker activation. You need to provide the
trackers IMEI number (refer to point 1, section “Optional”).
The tracker’s default password is “123456”. Make sure to change it as explained above.
Questions? Contact inuvi at [email protected] or visit https://inuvi.net/service-desk/ for
support ticket request.
Revision: 14022020_CHL_V3