2
3Tighten all bolts and cover with bolt caps (Lh) where
necessary. Place the cushion (E) onto the chair frame
and fasten the Velcros straps.
4
Fig. 3
Repeat procedure for the other reclining chair.
OTTOMAN ASSEMBLY
5
Tighten all bolts using the Allen wrench (Lg) and cover
with bolt caps (Lh) where necessary. Place the cushion (H)
onto the seat and fasten the Velcros straps.
Fig. 5
Repeat procedure for the other ottoman. 4
Fig. 6
C
D
A
B
Lb
B Ld
Lh
Ld
Lh
Lb
C
D
Le
Lf
Le
A
La
F
F
D
G
FD
G
F
G
F
F
D
FF
G
D
Ld
F
Lh
Lb
Ld
Lh
Lb
G
La
F
D
Lf
Le
Le
Attach the two arms (A & B) to the seat and back (C)
by inserting the 4 ends of the front and rear crossbars of the
seat and back (C) into the holes of the arms (A& B) per
drawing. See Fig.1. Attach the two ends of the leg
connector (D) to the arms (A& B). See Fig.2.
Line up the holes, insert a sleeve (Ld) into the holes of
the left arm (B), insert a long bolt (Lb) through the
sleeve (Ld), through the left arm (B) and secure into
the seat and back (C) for each hole. See Fig. 3. Do not
tighten completely. Repeat procedure for the other hole
and the other side. Align the holes, insert a short bolt (La)
through a metal washer (Le), through the connector (D),
through another metal washer (Le) and secure into a
nut (Lf). Do not tighten. Repeat the procedure for the
other side. See Fig.4.
Fig. 4
Attach the two ottoman arms (F) to the ottoman seat (G) by
inserting the 4 ends of seat (G) into the holes of the arms (F)
per drawing. See Fig.5. Attach the two ends of the leg
connector (D) to the arms (F). See Fig.6.
Line up the holes, insert a sleeve (Ld) into the holes of
the arm (F). Insert a long bolt (Lb) through the sleeve (Ld),
through the arm (F) and secure into the seat (G) for each
hole. See Fig. 7. Do not tighten completely. Repeat
procedure for the other hole and the other side. Align the
Fig. 7
holes, insert a short bolt (La) through a metal washer (Le),
through the connector (D), through another metal
washer (Le) and secure into a nut (Lf). Do not tighten.
Repeat the procedure for the other side. See Fig.8.
Fig. 8