Jaypro Sports LG-1X Lacrosse Goal User manual

Rev-A Page 1of 6
-- LG-1X Lacrosse Goal --
Installation Instructions
Call Jaypro Sports Equipment at 1-800-243-0533
during regular business hours for technical support.
www.jaypro.com

Rev-A Page 2of 6
LG-1X
PARTS LIST (QTY: EACH GOAL)
ITEM
IMAGE
DESCRIPTION
QTY
1
Goal Upright
1
2
Goal Bases (LEFT & RIGHT PAIRS)
1
3
Goal Covers (LEFT & RIGHT PAIRS)
1
4
Goal Cover Rear Plate
1
5
5/16” x 7/8” Long Flat HD Socket Screw
16
6
5/16” x 5/8” Long Flat HD Socket Screw
4
7
Net w/ Lace (SOLD SEPARATELY)
1
ITEM
IMAGE
DESCRIPTION
QTY

Rev-A Page 3of 6
Table of Contents
IMPORTANT NOTICE:
1) BEFORE EACH USE CHECK EQUIPMENT FOR PROPER CONNECTING
HARDWARE AND STRUCTURAL INTEGRITY. REPLACE DAMAGED OR
MISSING HARDWARE IMMEDIATELY.
2) NEVER ALLOW ANYONE TO CLIMB OR HANG ON THE NET OR GOAL
FRAME. AS SERIOUS INJURY OR DAMAGE TO THE EQUIPMENT MAY
OCCUR.
3) USE OF THIS EQUIPMENT OTHER THAN INTENDED, MAY BE
HAZARDOUS.
4) ALTERATION OR MODIFICATION OF THIS EQUIPMENT MAY BE
HAZARDOUS AND RESULT IN INJURY. FOR REPAIR OR
REPLACEMENT, CONTACT YOUR DEALER OR JAYPRO SPORTS.
Tools Require:
1
3/16” Allen Wrench
1
Socket Wrench
1
Tape Measure
1
Lithium Grease
oUnpack all parts and check against parts list to ensure that all have been
included.
oInspect all parts for damage. Report any damages to the trucking
company.
oTools required: tape measure, step ladder

Rev-A Page 4of 6
1. Lay out both left and right base members on the ground.
2. Loosely attach the rear corner plate, as shown. Do not tighten the screws but allow the
base members to freely move.
3. Space the front inserts at roughly 74” apart, center to center.
!Do Not Tighten !
5/8” LONG, 4 PLACES

Rev-A Page 5of 6
4. Apply some lithium grease to both inserts and the inside of the uprights
5. Carefully slide the uprights onto the inserts –this is a two person job. Note: To avoid
binding, it is very important that both uprights be slid onto the inserts in unison.
6. Once the front goal is fully slid down over the inserts, fully tighten the screws holding to
rear corner plate.
Lithium Grease
Lithium Grease

Rev-A Page 6of 6
7. Lay the net out and identify the top corner. Using a zip tie or piece of string, attached
the center of the net to the center of the crossbar. Make any adjustments necessary to
ensure the net is centered.
8. Lace the net to the face of the goal (see the lacing detail below).
9. Secure both sides of the net to the base by sandwiching it between the base and top
plate. Loosely install all the top plate screws before tightening.
10. Lace the back corner of the net to the net rail on the corner piece.
LACE NET THRU BENT RODS
SANDWICH NET BETWEEN PLATES