S Compone
N nt ExPlanation
I lndicator lndicating the opemting state of external power
' light suoply
- Touch oen
, ;;,-"'-" Location ofthe touch pren
Speaker
Powering on/ off md sleep
9 Reset key Restafi the system
1.2 Power Supply & Charging
Chuge the GPS navigator futly with the charger before firet use.
L2. I Power Supply
The GPS 84H-3 can be powered by the built-in battery or extemal power supply.
When the GPS navigator is uconnected to the charger, it is powered by the
Li-polymer battery. The battery capacity icon E in L. ,yu.* main interface
shows curent residual battery capacity.
When the GPS nayigator is connected to the chilger, it is powered by extemal power
and the banery is charged.
lAttention] The GPS navigator adopts intemal non-removable Li-polymer battery.
To avoid battery rupture, explosion, release of hmdous substance or bum, do not
unpack, pierce, strike on or discard the battery in fire or water.
1.2.2 Charging by Charger
The GPS navigator must be chtrged with the chrger before first use.
Plug the USB teminal of the chuger into the USB port on the left side of the OPS
navigator and the other to the power socket to supply power and charge the GPS
navigator
lNote] The charging indicator light is red duing charging. Do not unplug rhe
chuge until the battery is fully chilged md the indicator light tums green. Please
charge the GPS navigator when the battery is low or used up in succeeding use.
1.2.3 Chuging by Ca Charger
Plug one terminal of the cu chilger into the USB port on the left side of the GPS
navigator and the other to the charging pon to supply power and charge the GPS
navrgatoL
[Note] Plug in the car charger after the automobile is started to avoid damage due to
cutrent surge.
1.3 Basic Use.
1.3.1 Powering or/off & Sleep
2.3. I.l Powering on
Press the power key on the top side of the GpS navigator for at least two seconds to
power it on.
[Note] Great humidity fluctuation may lead to short circuit of the GpS navigaror.
Power on the navigator after it has accommodated to new environment.
2.3. L2. Powering off& Sleep
Long press the power key to power offthe CpS navigator the following interface
1.3.2 Restarting the System
When the system does not response, press the reset key on the back of the GpS
navigator to restart the system.
fRelevant Information] The following situations might lead to no response of the
system.
l. Delay or stagnancy in interface switching;
2. Failure offunction activation with overlong execution;
3. Failure to power on/offthe GPS navigator by pressing the power key
fNote] Restarting the system by pressing the reset key will result in loss of unsaved
data. Please backup your data regularly.
1.3.3 Fixing the GPS Navigator with Mounting Kir
The mounting kit is composed of a back splint and a bracket. To use the GpS
navigator in an automobile, fix it on the dashboard under the front windshield.
lNote] Do not place the GPS navigator in positions obstucting the driver,s vision.
Do not place it without fixing it, or in the place ofair bag or the area after the air bag
is inflated,
1.3.4 Using T-FLASH Card
Copy mapping applications, map data and media files in a ?FLASH card. Insen the
card in the corresponding slor.
INote] L Do not take our the T-FLASH card while an navigation program is being
run or a media file is being played.
2. To avoid drop or crash of the IFLASH card, do not exen heavy pressure
5
kev
- Eamhone
) ,' Lonnected wlth the stereophone
tack
6 MlNl Communicating with PC via MINI USB cable md'
- USB pon used as the charging pon
- Batterv Banerv lnslde
cover
8 SIM slot SIM cild inside
