menu 1 feedback, algorithm & velocity control
1.1 feedback left knob
degree of modulation of operator 1 to itself
1.1 algorithm right knob
modulators are the operators that modulate the
carriers carriers are the operators you can hear
1.2 velocity right knob
on/off midi velocity controlled operators
menu 3 adsr envelope
3.1 attack rate left knob
3.1 total level right knob
3.2 decay rate left knob
3.2 secondary total level right knob
3.3 secondary decay rate left knob
3.3 release rate right knob
3.4 rate or key scaling right knob
menu 2 frequency ratio
2.1 frequency multiplier right knob
operator‘s frequency multiplier
2.2 frequency fine detune left knob
fine detune of selected frequency multiplier
2.2 frequency coarse detune 2 right knob
coarse detune of selected frequency multiplier
*different frequency ratios between carrier and its modulator
will produce different overtones
menu 4 low frequency oscillator (lfo)
4.1 lfo frequency left knob
global for 4 operators
4.1 frequency modulation sensitivity right knob
global for 4 operators
4.2 amplitude modulation on/off left knob
for every individual operator
4.2 amplitude modulation sensitivity right knob
global for 4 operators
menu 5 low frequency oscillator (lfo)
5.1 phase modulation depth right knob
5.2 amplitude modulation depth right knob
5.3 phase and amplitude modulation waveform
right knob
these submenus are selected with the left knob
menu 6 fm patches and midi channels
6.1 edit midi ch/bank 0 preset selection left knob
6.2 save preset in midi ch selection left knob
*number: midi channel number : midi bank 0 preset
*midi channel 1 has 8 voice polyphony
midi channels 2 –8 are monophonic
*number on top shows the preset that is being edited
6.3 load 8 presets from sd card to midi channels
*presets need to be named as patch0x.dmp (x from 1 to 8)
6.4 save all 8 presets from midi channels to sd card
*presets need to be renamed from patch0x.DMP to patch0x.dmp (x
from 1 to 8) to load correctly on deflemask software
