Kiddicare Mikah User manual

mikah
Cotbed
IMPORTANT:
RETAIN FOR FUTURE REFERENCE.
READ CAREFULLY

10 20 30 40 50 60 70 80 90 1000
(millimeters) 3
parts
Tools required
Measure
included
not
included
A B C
E F
X2X2X1
X8X8X8
45mm 56mm
D

1
4
assembly-cot
A
C
A
B
B

2
5
assembly-cot
back
X4
D
F
F
front
A
A
C
C
A
back
X4
Dfront
X4
F
F
F

3
6
assembly-cot
C
A
B
A
X4
E
B
A
A
B
B
X4
E
B

4
7
assembly-cot
1
2
3
（1）0-6months
（2）6-9months
（3）9 + months

5
8
assembly-cot
A
A
A
C

6
9
assembly-cot
back
X4
D
F
front
F
F
F

Warning: Do not use the cot if any part is broken, torn or missing and use only spare
parts approved by the manufacturer.
Warning : Do not leave anything in the cot or place the cot close to another product,
which could provide a foothold or present a danger of suffocation or strangulation,
e.g. strings, blind/curtain cords, etc.
Warning: Do not use more than one mattress in the cot.
Warning: Be aware of the risk of open fires and other sources of strong heat, such as
electric bar fires, gas fires, etc. near the vicinity of the cot.
Warning: Do not place this child’s bed near heat sources, windows and other furniture.
• The base can be adjusted in height in cot mode, but the lowest position is the
safest and should always be used in that position as soon as the baby is old
enough to sit up.
• This product is suitable for a mattress of 1400mm in length and 700mm in width.
• The length and width of the mattress shall be no less to ensure the gap between
the mattress and the sides and ends does not exceed 30mm.
• The thickness of the mattress shall be such that the internal height (surface of the
mattress to the upper edge of the cot frame) is at least 500mm in the lowest position
of the cot base and at least 200mm in the highest position of the cot base.
• The bed mode is suitable for a child from 18 months old to 4 years old.
• Children are likely to play, bounce, jump and climb on beds, therefore the child’s
bed should not be placed too close to other furniture or windows, blind cords,
curtain pulls or other strings or cords. It should be placed either tight to any wall
or have a gap of 300mm between the wall and the side of the bed.
• The bed can be carefully dismantled for storage and transportation.
• To prevent injury from falls the cot should no longer be used for the child once
they are able to climb out of the cot.
• This product conforms to: BS EN 716-1: 2008 + A1: 2013 and BS 8509: 2008 + A1: 2011
Kiddicare
Club Way,
Cygnet Park,
Hampton,
Peterborough,
Cambridgeshire PE7 8JA Customer Care: [e-mail]
Safety
Maintenance
Cleaning
care
All assembly fittings should be tightened properly and should be checked regularly and
re-tightened as necessary.
Your cot can be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia based household polishes.