Kolombo K-2000 User manual

OWNER`S MANUAL

Preliminary
2
PRODUCTS RANGE
K-1000
K-2000
Kolombo Technologies Ltd Model No.: K-2000
IC: 4985A-K2000100 FCC ID: RYAK2000100
*This device complies with Part 15 of the FCC Rules. Operation is
subject to the following two conditions: (1) This device may not cause
harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
Made in Canada

Preliminary
3
Introduction __________________________________________________________________4
About this owner`s manual ______________________________________________________5
K-1000 operational functions ____________________________________________________5
Disarming the system ______________________________________________________________ 5
Rearming the system_______________________________________________________________ 5
Engaging valet mode**_____________________________________________________________ 5
Disengaging valet mode ____________________________________________________________ 5
Key chain’s battery ________________________________________________________________ 6
K-2000 operational functions (car module) _________________________________________6
Disarming the system ______________________________________________________________ 6
Rearming the system_______________________________________________________________ 6
Engaging valet mode**_____________________________________________________________ 6
Disengaging valet mode ____________________________________________________________ 7
Key chain’s battery ________________________________________________________________ 7
K-2000 operational functions (modem module) ______________________________________7
General informations ___________________________________________________________7
Key chain ________________________________________________________________________ 7
Maintenance _____________________________________________________________________ 7
Installing the system in a new car ____________________________________________________ 7
Concept of secured area ____________________________________________________________ 8
Information to user ____________________________________________________________8
Warranty _____________________________________________________________________9

Preliminary
4
Introduction
Kolombo Technologies Ltd is proud to present a new way to prevent the robbery of your
car. The unique design of the K series allows the security system to be installed anywhere in your
car. This system absolutely undetectable and its keys cannot be copied. Kolombo’s security
system is interactive and you are always aware of the status of your security system thanks to the
audible interface. Even though there is no visible evidence of the presence of a Kolombo system
in your car, you will always be notified audibly by its presence.
According to the level of protection requested, Kolombo offers a selection of product
starting with the K-1000 version. This system will forbid any ignition of your car that is
attempted without the presence of a valid encrypted key. The disabling of the vehicle is done by
shutting down up to three electrical circuits. The electrical circuits will only be reactivated with a
valid encrypted key.
If a higher protection level is required, the K-2000 system is then, the solution. In addition
to what the K-1000 is capable, the K-2000 offers transparent key holder identification and an
R.F. communication link with your home or office module that buzzes if an alert is detected. This
creates a made safe zone at your main residence or your place of work. In other words, you are
warned within seconds that your car has been started illegally.

Preliminary
5
About this owner`s manual
This manual reports all operating steps of the K series systems and validates all the
warranty coverage for every component.
K-1000 operational functions
Disarming the system
Any start attempt of a car in any other way then the one explained herein will fail.
Once you are ready to start your car, press the button on your keychain. The K-1000 will
reply to you with a beep telling that a valid encrypted code has been received. If no beep has been
heard, press the button on your keychain again until you hear the confirmation. After a valid
identification, you have 8 seconds to start your engine.
Rearming the system
The return to an armed state of the system is always made automatically. The K-1000
confirms the rearming by producing two short buzzes. The rearming will happen in these
situations:
•If the allowed 8 seconds to start your engine expires.
•When you turn off your engine.
Engaging valet mode**
To put the system into the valet mode, the K-1000 has to receive three valid encrypted
codes within 8 seconds. In other words, you have to activate your keychain to hear three
confirmation’s beeps from the K-1000 within 8 seconds. The K-1000 confirms the state of valet
mode by producing three short buzzes.
Disengaging valet mode
The next time you start your car with a valid encrypted code, the system will return in
normal mode. The K-1000 will confirm the return to normal mode by producing three short
buzzes.
** Caution: When in valet mode, your car can be started without a keychain.

Preliminary
6
Keychain’s battery
When your keychain’s battery is near the end, the K-1000 produces a warning sound
every three minutes while the car is running to warn you that you have to change your battery.
You will have at least 7 days to change your battery. To change the battery, remove the back of
the keychain’s enclosure. You will see the battery in its support. Use a small screwdriver to pop
out the battery and replace it. The battery type is CR2032.
K-2000 operational functions (car module)
Disarming the system
Any start attempt of a car in any other way then the one explained herein will fail.
Once you are ready to start your car, press the brake pedal. The K-2000 will then question
the keychain for an encrypted code. The K-2000 will reply to you with a beep telling that a valid
encrypted code has been received. If no beep has been heard, press the brake pedal until you hear
the confirmation. After a valid identification, you have 8 seconds to start your engine.
Once you have started your car, the K-2000 will inform the remote modem module that it
is leaving the secured area.
Rearming the system
The return to an armed state of the system is always made automatically. The K-2000
confirms the rearming by producing two short buzzes. The rearming will happen in these
situations:
•If the allowed 8 seconds to start your engine expires.
•When you turn off your engine.
Once your car has been shut down in a secured area, the K-2000 will inform the remote
modem module that it is back in the secured area.
Engaging valet mode**
To put the system into the valet mode, the K-2000 has to receive three valid encrypted
codes within 8 seconds. In other words, you have to activate your keychain via the brake pedal to
hear three confirmation’s beep from the K-2000 within 8 seconds. The K-2000 confirms the state
of valet mode by producing three short buzzes.

Preliminary
7
Disengaging valet mode
The next time you start your car with a valid encrypted code, the system will return in
normal mode. The K-2000 will confirm the return to normal mode by producing three short
buzzes.
** Caution: When in valet mode, your car can be started without the keychain.
Keychain’s battery
When your key chain’s battery is getting low, the K-2000 will produce a warning sound
every three minutes while the car is running to warn you that you have to change your battery.
You have at least 7 days to change your battery. To change the battery, remove the back of the
keychain’s enclosure. You will see the battery in its support. Use a small screwdriver to pop out
the battery and replace it. The battery type is CR2032.
K-2000 operational functions (modem module)
To come
General informations
Keychain
Two keychains are included with the purchase of a K series system. But a total of 7 keys
can be programmed for the same car. Also, the same key can be programmed for several cars. So
you only need one key to use with any car in your parking lot.
Maintenance
The system needs no maintenance. Only the key chain’s battery may need to be replaced
after a certain time. The K series systems will detect a low battery voltage and warn you with
sufficient time to change it to make sure you will not get stuck. With the K-2000 version and
higher, the house module will also inform you of the low state of the keychain’s battery.
Installing the system in a new car

Preliminary
8
Since the Kolombo security system is yours, when comes the time to change your car, you
can transfer the security system into your new car.*
* Fees are assumed by the owner.
Concept of secured area
A secured area is created with the K-2000 modem module. This zone can be located either
at your main residence or your working place. If an attack happens when your car is in the
secured area, you are immediately warned. This gives you the opportunity to take proper actions
within a respectable time.
Information to user
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and (2)
This device must accept any interference received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply with the limits for Class B Digital
Device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates and can radiate radio frequency energy and, if not installed and
used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures.
•Reorient or relocate the receiving antenna
•Increase the separation between the equipment and receiver
•Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
•Consult the dealer or an experienced radio/TV technician for help
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.

Preliminary
9
Warranty
To come