Kontakt.io Asset Tag 2
Standard set of 20pcs
User Manual
PNR: KHWBC502F001
Introduction
For proper operation, it is necessary to
use the entire set of devices - 20 pcs
Preparation of the device:
1. As an attachment to the device in the
package there is a flyer with your unique order
number: keep it to claim your devices on cloud.
2. Using the start.kontakt.io website, create a
customer account and use the order number to
add your devices to the customer panel.
3. Download the mobile app and configure
your Asset Tag 2.
4. Asset Tag 2 is now operational.
5. Long press of the button allows you to turn
off the beacon (only if the configuration allows
it). Activation works in the opposite way.
Asset Tag 2 continuously transmits Bluetooth
signals for tracking purposes and continuously
scans for infrared signals to track your location.
In the event of a malfunction, users should
contact Technical Support for assistance and
replacement of defective and still under
warranty devices.
Contact support at: support@kontakt.io
Application:
- Asset Tag 2 is designed for location tracking -
using iBeacon and Eddystone format via radio
signal. The radio signal is transmitted and
received via the BLE chip (nRF52832)
- Activation takes place by pressing the button
for 5 seconds
- Asset Tag 2 has 2 holes, thanks to which it is
possible to install it with zip ties
Characteristics
The manufacturer and name of the device can
be found on the original packaging in which the
device is delivered.
Device dimensions: 49 mm x 49 mm; 15 mm.
The housing of the device is factory sealed and
cannot be opened.
Technology:
•Chip nRF52832
•Temperature sensor
•IR sensor
•Accelerometer
Communication:
○ Bluetooth v 4.2 BR / EDR
○ Bluetooth 5.0 (optional)
○ IR sensor
○ Range up to 50 meters
Technical requirements:
● Working temperature -25ºC ~ 85ºC
● Working humidity 10% ~ 90% - non-
condensing
Frequency ( MHZ): 2402.0 - 2480.0
Maximum radio power: +4 dBm (2.5119 mW)
WARNING
Asset Tag 2 contains
electronic elements and a
battery (2x model: ER14250)
which should be properly
disposed of. If a beacon needs
to be disposed of, please contact the
manufacturer technical support first.
FCC Caution
This device complies with part 15 of applicable
FCC Rules. Its operation is subject to the
following two conditions: (1) this device may not
cause harmful interference, and (2) this device
must accept any interference received, including
interference that may cause undesired
operation. Any changes or modifications not
expressly approved by the party responsible for
compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation. This
equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning
the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
●Reorient or relocate the receiving
antenna.
●Increase the separation between the
equipment and receiver.
●Connect the equipment into an outlet
on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced
radio/TV technician for help.
The device has been evaluated to meet general
RF exposure requirements. The device can be
used in portable exposure conditions without
restriction.
