Leeson 174186 User manual

Drive Size Drive Width DIN RailMounting Kit Part Number Bracket Width
A 2.88" 174186 3.75"
B 3.76" 174187 4.63"
C 5.02" 174188 5.89"
SUB-MICROSERIESDINRAILMOUNTINGKIT
Part Number(s) 174186, 174187, 174188
ManualNumber: SDIN06C
GENERAL
The Sub-Micro Series DIN rail mounting kit allows Sub-Micro Series drives to be mounted to a standard 35mm DIN rail, which
simplifies panel layouts and installation. The kit uses mounting brackets that fasten to the DIN rail. The brackets allow for
mounting at different heights on the DIN rail so that different size drives may be aligned with the top, bottom, or center of the
drives at the same level to suit various wire-routing styles.
TherearethreedifferentversionsoftheDINRailMountingKit(P/N174186,174187,174188). Thefollowingtableillustrateswhich
kit should be used depending on the size of the drive:
PARTS LIST
Each kit includes the following parts:
DIN Rail Mounting Brackets (Quantity 6)
Mounting Screws (Quantity 24)
ClampingScrews (Quantity 6,except kit version174188 has 12 ClampingScrews)
NOTE: The DIN Rail Mounting Brackets in kit version 174187 can also be used to mountAsize drives with 2.88” width.
INSTALLATION
Refer to the drawings on the back of this page during installation.
1. Position the DIN Rail Mounting Bracket onto the DIN rail such that the top edge of the DIN rail fits into the desired slot on
the back of the DIN Rail Mounting Bracket. NOTE: The DIN Rail Mounting Bracket has several mounting positions
which allow different size drives to be mounted with the top, bottom, or center of the drives at the same level.
2. Screw the Clamping Screw into the hole that matches the selected mounting position. The Clamping Screw should engage
thebottomedgeoftheDIN rail to hold the DIN Rail MountingBracketsecurelyinplace. NOTE: Kitversion174188 uses two
(2)ClampingScrews.
3. Mountthe Sub-Micro Seriesdrive onto the DIN Rail Mounting Bracket usingthe four (4) Mounting Screws included with the
kit.
4. The tab at the bottom of the DIN Rail Mounting Bracket can be used as an additional mounting point to fasten the DIN Rail
Mounting Bracket directly to the back panel. A screw for this is NOT provided in the kit.
LEESON ElectricLEESON Electric
LEESON ElectricLEESON Electric
LEESON Electric • 2100 Washington St. • Grafton, WI 53024 • Ph: [phone] • Fax: [phone] • www.leeson.com

EXPLODED VIEW
MOUNTING POSITIONS
The diagrams below illustrate the different mounting positions that are possible with the DIN Rail Mounting Kit. Drives can be
mounted next to each other with the top, bottom, or center of the drives aligned. The diagrams indicate recommended and
alternate mounting positions to use on each DIN Rail Mounting Bracket to achieve the desired alignment.
TOPALIGNEDBOTTOM ALIGNED
CENTERALIGNED
RECOMMENDEDDIN
RAILPOSITION
ALTERNATEDINRAIL
POSITION
5.13"
1.00"
5.89"3.75" 4.63"
3.13"
1.00"
4.13"
1.00"
LEESON ElectricLEESON Electric
LEESON ElectricLEESON Electric
LEESON Electric • 2100 Washington St. • Grafton, WI 53024 • Ph: [phone] • Fax: [phone] • www.leeson.com