To enjoy Programmed Playback
Press again after you make the list.
a
Press twice to exit from Programmed
Playback mode.
To delete Programmed Playback List
Press in stop status.
a
bPress repeatedly to select a track/le.
Press to delete selected song.
c
DELETE
Programmed Playback
bPress to play the list.
Specication
ENGLISH
Power Requirements 120 V ~ 60 Hz
Power Consumption 50 W
Bus Power Supply
(USB) 5 V 0500 mA
Total Output 260 W
Design and specications are subject to change
without notice.
Additional Information
Music File Requirement
Sampling frequency
yMP3 : 32 - 48 kHz
yWMA : 32 - 48 kHz
Bit rate
yMP3 : 32 - 320 kbps
yWMA : 40 - 192 kbps
Maximum les Data CD : 999 / USB : 2000
Maximum folders Data CD : 99 / USB : 200
File extensions
y“.mp3”
y“.wma”
CD-ROM le format ISO9660+JOLIET
USB Flash Drive Devices that support USB2.0 or USB1.1.
Bluetooth Codec SBC
The USB function of this unit does not support all USB devices.
,
External HDD, Card readers, Locked devices, or hard type USB devices are not supported.
Using NTFS le system is not supported. (Only FAT(16/ 32) le system is supported.)
,
,
,
The DTS is not supported. In case of DTS audio format, audio is not output.
Safety Information
Press to enter the edit mode.
a
bSelect a track/le and conrm.
Press again to exit from the edit mode.
c
You can make a playlist of your favourite tracks/les from a disc or USB device using Programmed Playback.
To make Programmed Playback list
A playlist of up to 20 tracks/les can be entered for CD/USB1/USB2.
,
Repeat steps bto store other les.
,
,This function is supported only on stop status.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT
REMOVE COVER (OR BACK) NO USER-SERVICEABLE PARTS INSIDE
REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.
This lightning ash with arrowhead symbol
within an equilateral triangle is intended to
alert the user to the presence of uninsulated
dangerous voltage within the product’s
enclosure that may be of sucient magnitude
to constitute a risk of electric shock to persons.
The exclamation point within an equilateral
triangle is intended to alert the user to
the presence of important operating and
maintenance (servicing) instructions in the
literature accompanying the product.
WARNING: This product contains chemicals known to the State of
California to cause cancer and birth defects or other reproductive
harm. Wash hands after handling.
WARNING: TO PREVENT FIRE OR ELECTRIC SHOCK HAZARD, DO
NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE.
CAUTION: The apparatus shall not be exposed to water (dripping
or splashing) and no objects lled with liquids, such as vases, shall
be placed on the apparatus.
WARNING: Do not install this equipment in a conned space such
as a book case or similar unit.
CAUTION: Do not use high voltage products around this product.
(ex. Electrical swatter) This product may malfunction due to
electrical shock.
CAUTION: Do not block any ventilation openings. Install in
accordance with the manufacturer’s instructions.
Slots and openings in the cabinet are provided for ventilation and
to ensure reliable operation of the product and to protect it from
over heating. The openings shall be never be blocked by placing
the product on a bed, sofa, rug or other similar surface. This product
shall not be placed in a built-in installation such as a bookcase or
rack unless proper ventilation is provided or the manufacturer’s
instruction has been adhered to.
CAUTION: This product employs a Laser System.To ensure
proper use of this product, please read this owner’s manual
carefully and retain it for future reference. Shall the unit
require maintenance, contact an authorized service center.
Use of controls, adjustments or the performance of
procedures other than those specied herein may result in
hazardous radiation exposure. To prevent direct exposure
to laser beam, do not try to open the enclosure.
CAUTION concerning the Power cord
The Power Plug is the disconnecting device. In case of an
emergency, the Power Plug must remain readily accessible.
This device is equipped with a portable battery or accumulator.
Safety way to remove the battery or the battery from the
equipment: Remove the old battery or battery pack, follow the
steps in reverse order than the assembly. To prevent contamination
of the environment and bring on possible threat to human
and animal health, the old battery or the battery put it in the
appropriate container at designated collection points. Do not
dispose of batteries or battery together with other waste. It is
recommended that you use local, free reimbursement systems
batteries and accumulators. The battery shall not be exposed to
excessive heat such as sunshine, re or the like.
IMPORTANT SAFETY
INSTRUCTIONS
1. Read these instructions.
2. Keep these instructions.
3. Heed all warnings.
4. Follow all instructions.
5. Do not use this apparatus near water.
6. Clean only with dry cloth.
7. Do not block any ventilation openings. Install in accordance
with the manufacturer’s instructions.
8. Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including ampliers) that
produce heat.
9. Do not defeat the safety purpose of the polarized or grounding-
type plug. A polarized plug has two blades with one wider than
the other. A grounding type plug has two blades and a third
grounding prong. The wide blade or the third prong are pro-
vided for your safety. If the provided plug does not t into your
outlet, consult an electrician for replacement of the obsolete
outlet.
10.Protect the power cord from being walked on or pinched par-
ticularly at plugs, convenience receptacles, and the point where
they exit from the apparatus.
11.Only use attachments/accessories specied by the manufac-
turer.
12.Use only with the cart, stand, tripod, bracket,
or table specified by the manufacturer,
or sold with the apparatus. When a cart is
used, use caution when moving the cart/
apparatus combination to avoid injury from
tip-over.
13.Unplug this apparatus during lightning storms or when unused
for long periods of time.
14.Refer all servicing to qualied service personnel. Servicing is
required when the apparatus has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the apparatus, the apparatus
has been exposed to rain or moisture, does not operate nor-
mally, or has been dropped.
FCC Compliance Statement
This device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including
interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This
equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
yReorient or relocate the receiving antenna.
yIncrease the separation between the equipment and
receiver.
yConnect the equipment into an outlet on a circuit
dierent from that to which the receiver is connected.
yConsult the dealer or an experienced radio/TV
technician for help.
CAUTION: Any changes or modications not expressly approved
by the party responsible for compliance could void the user’s
authority to operate this equipment
FCC WARNING : This equipment may generate or use radio
frequency energy. changes or modications to this equipment may
cause harmful interference unless the modications are expressly
approved in the instruction manual. The user could lose the
authority to operate this equipment if an unauthorized change or
modication is made.
FCC RF Radiation Exposure Statement : This equipment complies
with FCC radiation exposure limits set forth for an uncontrolled
environment. This equipment should be installed and operated
with minimum distance 20 cm between the radiator and your
body. End users must follow the specic operating instructions for
satisfying RF exposure compliance. This transmitter must not be
co-located or operating in conjunction with any other antenna or
transmitter.
CAUTION: Regulations of the FCC and FAA prohibit airborne
operation of radio-frequency wireless devices because their signals
could interfere with critical aircraft instruments.
Responsible Party :
LG Electronics USA, Inc. 1000 Sylvan Avenue
Englewood Clis, NJ 07632
TEL. : +1-800-243-0000
CM4350-FB_DUSALLK_SIM_1487_1488.indd 4 2015-02-26 �� 2:27:36
