1
M051-00K32-A086
Life Fitness LCD Entertainment System
How To Program TV Consoles
Special service tools required: none
Description: Procedures for programming a.)
EZ consoles (on this page) and b.) TV consoles
with remote control units (on page 2).
Kit Contents: Programming device and cable
(see illustration). A 9-volt battery (not
supplied) is required to reprogram the TV
console.
Procedure: In both procedures, the TV
console stays mounted and the power and
coax cables stay plugged in (see illustration).
To program the TV on EZ console products:
1. Remove the EZ console cable from the
black 8-pin connector on the back of
the console.
2. Plug the C-SAFE cord into that 8-pin
connector.
3. Place the 9-volt battery in the
programmer.
4. Plug the other end of the C-SAFE cord
into the programmer.
5. The programmer will give this
feedback that the updating procedure
is taking place:
a. The green LED will glow
steadily.
b. The yellow LED will then glow
steadily.
c. The yellow LED will then begin
flashing.
d. The console software has been
updated when the green LED
begins flashing slowly.
6. Unplug the C-SAFE cord from the
programmer.
7. Unplug the C-SAFE cord from the
console.
8. Reconnect the EZ console cable.
9. Verify that the console’s software
version matches the software version on the programmer. If the console version
number is still lower, repeat the procedure.
Programmer
Battery Compartment Cover
9-volt Battery
Connector
C-SAFE Cord C-SAFE Connector
Tto programmer
Tto console
9-volt Battery
Coax
Cable Power
Cable
Black 8-Pin C-SAFE Connector
(for in-console control)
do not useD
