Life Span Workplace DT-5 User manual

FITNESS
QUICK START
DT5 TREADMILL DESK
2. Attach the 9 Pin Data Cable
Connect to the desk’s right base foot
and push into the port on the back
of the treadmill. Do not screw in.
3. Attach the Power Cord
Connect the power cord to the base
of the treadmill then to a power
outlet.
4. Turn the Power Switch on
4. Conrm that the Safety Key is securely in place
5. Press the Power button
6. Press and hold the Stop button for 1-3 seconds to reset
the console
Stand on the siderails of treadmill.
7. Press Start
The treadmill belt will start to move. You can begin walking.
8. Adjust the speed with the up and down arrow buttons
9. Press Stop when you are nished
4
32
lifespanfitness.com
4
5 67 89
1. Position the treadmill
under your desk
Begin Here

FITNESS
PROBLEM:
The console is erratic or not
lighting up.
PROBLEM:
““UART” or “ “dc-6” appears in
the display.
PROBLEM:
The desktop surface is not level.
PROBLEM:
The treadmill motor seems
strained or E1 comes up after
several minutes of use.
SOLUTION:
Check to make sure the treadmill
desk is properly plugged in. Turn
the power switch o and back on
again and make sure the Safety
Key is in place. Make sure the
connectors located in the front
of the treadmill and under the
desktop are fully plugged in. If the
problem persists contact LifeSpan
Customer Service.
Customer Service: 877.654.3837 x 4
SOLUTION:
Turn the treadmill desk power
switch o. Unplug the power cord.
Disconnect the 9 pin data cable,
then reconnect it. Make sure
the thumb screws are properly
tightened. Plug in the power cord.
Turn the treadmill desk power
back on and check to see if it
functions properly.
SOLUTION:
Check to make sure the base feet
are on a level surface. Make sure
the manual height adjustment
knobs are in the same location
holes on each leg.
SOLUTION:
This problem usually occurs when
there is too much friction building
between the treadmill belt and
deck. The best thing to do is turn
the treadmill o, lubricate the
running belt with 100% silicone
(non-aerosol), and turn the
treadmill back on. Test the unit.
If E1 still comes up after testing,
contact LifeSpan Customer Service.
Scan
Time Dist Steps SpeedCal
Bluetooth
dc6
Scan
Time Dist Steps SpeedCal
Bluetooth
E1
Scan
Time Dist Steps SpeedCal
Bluetooth
Please see Owner’s Manual section Maintenance and Tips for more information.
TROUBLESHOOTING
lifespanfitness.com
DT5 TREADMILL DESK