Lighthub Direct BHRO10PIR User manual

INSTALLATION & SAFETY INSTRUCTIONS
MODEL: BHRO10PIR
These instructions are for guidance only
Read these instructions fully before using the light tting.
Retain these instructions for future reference.
PLEASE CONSULT A QUAILIFIED ELECTRICIAN
General safety instructions
• Ensure mains power is disconnected & switched off when installing the light tting
• Never look directly into the LED light source. The light emitted can contain the colour blue.
• To clean: Ensure that the downlight is disconnected from the mains and cannot be unintentionally
reconnected.
• Do not use in rooms in which there is a danger of explosion.
• Do not use near ammable materials.
• Do not place in water or other liquids.
• Never operate with wet hands.
• Never cover the equipment.
• Never operate when the casing is open, or when the wiring casing is missing or damaged, or when the
protective screen is defective.
• Never attempt to repair this unit yourself. Repairs should only be carried out by a qualied electrician
Manufacturer
HUB UK Group Ltd
The Oak Barn
West Park Road
Lingeld
RH7 6HT
UK
E-mail: [email protected]
Tel: [phone]
Please contact us if you have any
questions or queries regarding the
product

Installation Instructions
1. Make sure all mains power is disconnected before you install tting.
2. Remove trim from tting, gently pull on sides of trim to release. (FIG.1)
3. Remove screws and keep safe. (FIG.1)
4. Remove opal diffuser
5. Choose a at surface to t unit to.
6. Pierce through side knockouts to install tting on wall / ceiling (FIG.2)
7. Connect mains supply directly into terminal block on tting. Ensure all terminals a secured and tightened. (FIG.3)
Brown - (L) Live
Blue - (N) Neutral
8. Place opal diffuser back on tting, place and tighten screws back onto tting.
9. Place trim back on tting, make sure it is securly tted.
10. Switch mains on to check unit is working as required.
Recommendations
• Installation should be carried out in accordance of of the lastest I.E.E Wiring Regulations. Please consult a qualied
electrician.
• This tting is non-dimmable.
• IP Rated to IP54
• Class II Double insulated, earth is not required
• This unit has no replaceable parts.
Correct Disposal of this product
This marking indicates that this product should not be disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of material resources. To return your used device, please use
the return and collection systems or contact the retailer where the product was purchased. They can take this
product for environmental safe recycling.
FIG.1
FIG.2
FIG.3
PIR Sensor
• Detection Range: 8-12M
• Dection Range: 120 Degrees
• LUX Level Adjustment: 10-2000 Lux
• Time Delay: 10+5sec to 5+1min
• To adjust PIR settings, remove diffuser and adjust directly on PIR module at bottom of tting.
Product Advice - T: 01342 000 000 / Email: [e-mail]