WPS Mode
To ensure sufficient Wi-Fi signal, complete these steps with the camera near its final location but prior to mounting.
1. Connect the camera’s AC power adapter and plug it into a non-switched outlet.
2. Press the Menu button and use the Volume buttons to scroll to the WPS menu option (follow the audio prompts or
look for a flashing blue LED).
3. Press the Menu button to activate WPS Mode. The LED will flash blue.
4. Activate the WPS Mode on the router. The ADC-V622 will begin to connect to the Wi-Fi network. The LED will be
solid green when the connection is complete.
5. Add the device to the account by either selecting the account in MobileTech OR by using a web browser and
entering the following URL: www.alarm.com/addcamera
6. Select the camera from the video device list or type in its MAC address to begin adding the camera. The camera’s
MAC address is located on the back of the camera near the power cable.
7. Follow the on-screen instructions to finish adding the camera. You may configure camera settings using the
Customer Website.
You can now power down the camera and install it in its final location using the included hardware.
AP Mode
To ensure sufficient Wi-Fi signal, complete these steps with the camera near its final location but prior to mounting.
1. Connect the camera’s AC power adapter and plug it into a non-switched outlet.
2. Press the Menu button and use the Volume buttons to scroll to Access Point mode (follow the audio prompts or
look for a flashing white LED).
3. Press the Menu button to activate Access Point Mode. The LED will flash white.
4. On an Internet enabled device, connect to the Wi-Fi network “ADC-V622 (XX:XX:XX)” where XX:XX:XX is the last
six digits of the ADC-V622’s MAC address, which is located on the back of the device near the power cord.
5. On the same device, open a web browser and enter http://v622install in the URL field. Follow the on-screen
instructions to add the ADC-V622 to the Wi-Fi network. The LED will be solid green when the connection is
complete.
6. Add the device to the account by either selecting the account in MobileTech OR by using a web browser and
entering the following URL: www.alarm.com/addcamera
7. Select the camera from the video device list or type in its MAC address to begin adding the camera. The camera’s
MAC address is located on the back of the camera near the power cable.
8. Follow the on-screen instructions to finish adding the camera. You may configure camera settings using the
Customer Website.
You can now power down the camera and install it in its final location using the included hardware.
Ethernet Mode
Complete these steps prior to installing the camera in its final location.
1. Using an Ethernet cable, connect the camera to the network.
2. Connect the camera’s AC power adapter and plug it into a non-switched outlet (if not using a PoE connection).
https://answers.alarm.com/Installation_and_Troubleshooting/Video_Devices/180_HD_Camera_(ADC-V622)/180_HD_Camera_(ADC-V622)_-_Installation_Guide
Updated: Thu, 02 Aug 2018 15:57:41 GMT
2
