LITESHEET BriteCor AC BBS User manual

BBS/BSS BriteCor
AC Direct Surface Mount
Installation Manual

BBS/BSS BriteCor Surface Installation Manual
Page 2of 4
NOTES
•WARNING –Risk of fire or electric shock.
•WARNING - It is recommended that installation be
performed by a certified electrician.
•All electrical connections must be in compliance with local
codes, ordinances or the national electrical code (NEC).
Contact your municipal building department to learn about
your local codes, permits and/or inspections.
•Do not connect this Luminaire to an electrical system that
does not provide means for equipment grounding. Never
use a fixture in a two-wire system that is not grounded.
•If dimming functionality is included, use only with Litesheet
approved dimmers.
•Do not use excessive force when manipulating cables and
wires.
•WARNING –To prevent wiring damage or abrasion, do not
pinch wires between surfaces.
•WARNING –Only connect Luminaire to the voltage indicated
by the Luminaire label. It is intended for direct connection to
this voltage. DO NOT connect to a different or unknown
voltage.
CONTENTS OF KIT
•BBS/BSS Luminaire
•Mounting Hardware
•(4) Nylon wallboard anchors
•(4) #8 Screws
TOOLS AND ADDITIONAL PARTS REQUIRED
•Drill
•3/16” drill bit
•#2 Phillips head screwdriver
Document #: 11-0007
Rev: G
Date: 4/19/2022

LiteSheet Solutions
Page 3of 4
Preparation
1. Turn off power source.
2. Remove luminaire from packaging.
Installation
1. Drill out (4) pilot holes on BriteCor luminaire
flange to 3/16” diameter.
2. While holding the BriteCor luminaire to the
desired surface, mark the drilled hole locations
on the surface. Remove the BriteCor luminaire
and use a screwdriver to install anchors.
NOTE: For hard wallboard or double board
construction, pre-drill 3/16” hole in the
mounting surface before inserting anchors.
Anchors not needed for mounting to wood.

BBS/BSS BriteCor Surface Installation Manual
Page 4of 4
3. Hold luminaire to the surface, aligning the pilot
holes to the installed anchors. Attach the #8
screws to the anchors.
4. Wire the BriteCor luminaire using NEC approved
methods.
5. Provide power to the luminaire.