Little Kiwi Pikler Triangle User manual

Assembly Instructions –Pikler Triangle - Nov 2020 Rev A
Little Kiwi Pikler Triangle Assembly
Instructions
Thank you for purchasing the Little Kiwi Pikler Triangle! To ensure your little one is
as safe as possible, please follow the safety tips and assembly instructions below.
Safety Tips
-Do not overload the triangle. The triangle has been tested for up to 80kg but a maximum of two
children at any time.
-Do not modify the triangle or use the triangle with missing or damaged components.
-Do not use the triangle without the locking knob correctly installed.
-Only use the triangle on a hard, non-slip, level surface. Take care to ensure all 4 legs are firmly
planted on the ground.
Care Tips
-Never leave your triangle in areas of high moisture, the Triangle is not suitable for use outside.
-To clean your triangle, you may use a damp cloth and wipe down the coloured surface, taking
care not to overly wet the wood edges or rungs.
-Over the lifetime of the triangle, you may notice burrs and marks on the dowels or edges of the
legs. This is to be expected under normal use and it is recommended to lightly sand areas you
deem to be sharp or burred. This can be done with sandpaper that is 220 grit or finer.
-Routinely check to ensure all rungs are secure and do not rotate by hand. If the rung does rotate
and you cannot tighten the screws further, you may glue the rung in in place with a 2-part epoxy
or super glue.
Assembly tools required
-Electric Drill/Driver.
-PH2 Driver Bit.
-Screwdriver (optional).

Assembly Instructions –Pikler Triangle - Nov 2020 Rev A
Parts included the package
Assembly Instructions
Assemble Side A using Side A –Leg 1 (#1), Side A –Leg 2 (#2) and Dowel - Long (#6). Use
Buttonhead Screws (#9).

Assembly Instructions –Pikler Triangle - Nov 2020 Rev A
Place one dowel into the pocket of one leg and drive the screw in.
Ensure screws are fastened firmly and as straight as possible into the dowels. Assemble all
dowels into one leg first before lining up the pockets on the second leg and driving the
screws in.
Assemble Side B using Side B –Leg 1 (#3), Side B –Leg 2 (#4) and Dowel - Short (#5).
Place one dowel into the pocket of one leg and drive the screw in.
For the two highest rungs (circled in red) use Countersunk Screw (#10) on both sides, for the
remaining 4 rungs use Buttonhead Screws (#9).
Ensure screws are fastened firmly and as straight as possible into the dowels. Assemble all
dowels into one leg first before lining up the pockets on the second leg and driving the
screws in.
Slide Side B inside the legs of Side A.
Line up the hinge through holes and pockets. Insert Dowel –Hinge (#7) into each side,
ensuring the hinges bottom out inside the side A leg pockets. Fasten the hinge dowels firmly
using Buttonhead Screws (#9).
When in use, always insert Locking Knob (#8) into the hole and tighten firmly. This is a safety
measure to prevent the Pikler Triangle from closing.

Assembly Instructions –Pikler Triangle - Nov 2020 Rev A
Further tips:
-Once the triangle is fully assembled, check and make sure the rungs are all firm and
do not rotate. If rungs rotate, tighten the screws on each side of the rung with a
philips head screwdriver. You may hold the screwdriver in position on the screw and
rotate the rung to tighten it, for extra leverage.
-To ensure you do not lose your locking knob, once the triangle is folded closed for
storage, you may insert the locking knob from the inside of the triangle and thread it
in.