LoJack EDGE M User manual
061021
Toll Free Support Phone: 1-877-563-0032
Email: customer_suppor[email protected]om
GPS DEVICE
INSTALLATION GUIDE
LOJACK EDGE M
Installation Options:
1. The standard installation simply hard-wires to the vehicle. Edge M supports both 2-wire and OBD passthrough
install methods.
Standard Installation Instructions:
1. Using a digital voltmeter, locate a constant 12V source (meter
should read 12V with the vehicle’s ignition in the o position) and
a solid chassis ground location.
2. For installations without the OBDii pass through cable, cut o the
quick disconnect on the device harness and connect the red wire
to your constant 12V source and the black wire to ground.
3. Find a mounting location for the Edge M that is clear of metallic
obstructions from above that could cause interference with
GPS signal reception. Be sure that the Edge M is mounted in
a manner that positions the printed ‘This Side Down’ indicator
toward the floor of the vehicle. IMPORTANT: Take special care
to secure the device to a solid surface using zip ties. In order for
the accelerometer to work properly, the device must be firmly
attached to the vehicle.
4. The Edge M will only wake up with movement. The device will
need to be awoken with movement before validation of the install.
It will go back to sleep mode after 3 minutes if no additional
motion is detected.
5. On initial power up, the LED indicators should show a flashing
green LED and a flashing red LED while scanning for cellular and
GPS signals, respectively. When the green and red LEDs stop
flashing and remain solid, adequate cellular and signals have
been acquired.
Ground
Constant 12V
Cut here for Standard Installation
(Do not cut when using preinstall or OBDII Harness)
Important:
It may take up to 7 seconds to
see any LED activity and up to 15
minutes to get an initial
GPS lock.
Caution:
If, after 15 minutes, you are still
unable to get GPS and / or cellular
signals, reposition and try again.
LED Troubleshooting
Flashing = Scanning for Signal
Solid = Signal Acquired
Green = Cellular Signal
Red = GPS Signal
Please contact customer service at: Spireon.com
THIS
SIDE
DOWN
Installation Guide (Standard)
LoJack Edge M
GPS Device
Installation Guide (Standard)
Optional OBDii Pass-through Cable Installation Instructions:
1. Unclip or unscrew the vehicle’s stock OBDii plug from its mounting location.
2. Plug the OBDii pass-through cable into the stock OBDii port and clip or screw the opposite end into the
stock plug’s original mounting location using the supplied bracket where necessary.
3. To install the Edge, mount the device as instructed in Step 3 of the standard installation before plugging the
quick disconnect on the device harness into the one on the passthrough cable.
OBDII Pass-through Cable
(where applicable)
Edge M / ATS Harness
To OEM OBD Port
Please contact customer service at: Spireon.com
LoJack Edge M
GPS Device
