LoRa Alliance YO Analog User manual

Analog
1. Mount the device on a 35 mm DIN rail.
1
Quick Installation Guide
4. Statuses, colours and behaviour of the diode (if the device is properly
connected):
In case of problems, the device can be reset with the “Reset” buon.
Device is working correctly (power and memory) - GREEN colour
Device is working incorrectly (power and memory) - RED colour
LoRaWAN frame sent - single WHITE ash
Conrmaon from server aer receiving the frame - single WHITE ash
Frame failed to conrm within specied meout - single RED ash
LoRaWAN Disconnected - ashing BLUE
Connecng to BLE - ashing BLUE
4
Important! By default each input is congured as current. If you
want to congure one or more inputs as voltage you have to do it
before connecng sensors. The conguraon is possible via BLE.
Version 2 - December 2021

32
3. Screw the power supply wires to the device regardless of polarity
(6 - 30 V DC, 5 - 21 V AC).
2. Connect a 4-20 mA signal source and/or a 0-10 V voltage
measuring cable to the individual inputs of the device according
to the polarity shown on the enclosure label.
Pic. 4-20 mA circuit diagram