Lowrance Lowrance IWAY 350C User manual

1
Pub. 988-0148-992
Mounting Instructions
For Automotive GPS Receivers
This instruction sheet describes how to assemble and use the quick-
release flexible suction cup mount for Lowranceautomotive GPS re-
ceivers. The flexible suction cup mount is useful for mounting on glass
or other smooth surfaces.
These mounts allow you to make non-mar installations without drill-
ing, screws or permanent adhesives. And, since each mount is portable,
it's easy to transfer the GPS unit to another vehicle.
WARNING!
When a GPS receiver is used in an automobile the driver
is solely responsible for operating the vehicle in a safe
manner. Drivers must maintain full surveillance of all
pertinent driving conditions at all times.
An accident or collision resulting in damage to property,
personal injury or death could occur if the operator of a
GPS-equipped vehicle fails to pay full attention to travel
conditions and vehicle operation while the vehicle is in
motion.
Do not attempt to configure, adjust or enter information
into your GPS unit while driving.
When mounting a GPS unit in an automobile you must
avoid any installation that obscures important instru-
ments and controls or restricts the driver's view through
the vehicle's windows.
Avoid placing the GPS where it could be propelled by an
activated airbag. Some states restrict mounting any
electronic device in any location on an automobile dash.
Be sure to check your local laws before using these
mounts.
Be sure to check the suction mount for adequate adhe-
sion each time you use the unit and reinstall it if neces-
sary.
This is a portable mounting device and the normal heat-
ing and cooling cycle of a car's interior will eventually


2
loosen the seal. A loose suction cup could allow the unit
to fall or come loose during vehicle operations.
The iWAY package includes a flexible arm mount. The base and arm
can be adjusted to a position that best suits your vehicle.
Mounting bracket packed with the iWAY350c GPS receiver.
Installing the flexible suction cup mount
The suction cup mount is designed to secure the GPS as it rests on an-
other surface. It is not designed to hold the unit suspended by the suc-
tion cup alone. The photo below shows how a GPS unit should be sup-
ported by the suction mount and another surface, which in this exam-
ple is a dashboard.
iWAY350c resting on dash with suction cup mount.
The mounting surface should be free of dirt and oil. Press the suction
Suction
cup base
Flexible
arm
Locking
leve
r
Quick
release
tab and
cradle.

3
cup against the mounting surface and, while maintaining pressure,
push the locking lever down until the arm is secure.
Suction cup base secured to windshield.
Mounting the unit is easiest if you first engage the bottom back edge in
the cradle (see following photo). After the bottom of the GPS unit is in
the cradle, push down on the front of the unit until it snaps into place.
Steps for attaching unit to mount.
Suction
release
tab
1. Engage bottom edge of GPS unit to back of cradle
as shown here . . .
2. …then push down
on front of unit until
it snaps into place.
Quick release tab.
Press suction cup against
mounting surface and engage
locking lever until arm is secure.
Cradle resting on dash.

4
Another option is to place the GPS unit in the cradle before attaching
the suction cup and arm to the mounting surface. Simply choose which
option works best for you.
To dismount the unit, push the quick release tab on the front of the
cradle down (see following photo). To remove the suction cup base, dis-
engage the locking lever and pull on the suction release tab to break
the vacuum seal.
Push quick release tab to dismount unit.
If the suction cup mount has problems staying on, clean the mounting
surface and the suction cup with alcohol, then reinstall. Moistening the
suction cup may help adhesion in some cases.
Storage Issues
Caution:
Do not leave this unit unattended on an automobile dashboard.
When your car is parked and the GPS is not in use, protect it
from theft and heat by storing it in an unobtrusive location
away from direct sunlight.
In warm seasons the temperature on a car's unventilated or non
air-conditioned dash can become hot enough to prevent the GPS
unit from operating.
Long Term Storage
When the GPS is not in use for an extended period of time we recom-
mend bringing it indoors and storing it at room temperature or in some
location with a temperature range of 60º to 90º F.
Quick
release
tab

5
iWAY™ 350c centered on a dashboard. This photo was taken at pas-
senger eye level. Notice how the unit was placed so that it does not
obstruct the view of the road ahead through the windshield.
See your Lowrance dealer or visit the LEI web site, www.lei-
extras.com, for the latest options stocked by LEI; the accessory source
for Lowrance and Lowrance Automotive.
If you have questions contact us at the following phone numbers: In the
U.S., call LEI Extras toll-free at 800-324-0045, 8 a.m. to 4 p.m. Central
Standard Time, M-F. In Canada, call toll-free 800-661-3983, 8 a.m. to 5
p.m. Eastern Standard Time, M-F.
If you live outside the U.S. and Canada, you should contact the dealer
in the country where you purchased your unit. To locate a dealer near
you, visit the Lowrance web site, www.lowrance.com, and look for the
Dealer Locator.

6
Pub. 988-0148-992 © Copyright 2005
All Rights Reserved
Printed in USA 102605 LEI