Lumi LDT46-C024 User manual

Use with products heavier than the rated weights indicated may result in instability causing possible injury.
Please closely follow the assembly instructions. Improper installation may result in damage or serious personal injury.
Safety gear and proper tools must be used. This product should only be installed by professionals.
Make sure that the supporting surface will safely support the combined weight of the equipment and all attached hardware and components.
Use the mounting screws provided and DO NOT OVER TIGHTEN mounting screws.
This product contains small items that could be a choking hazard if swallowed. Keep these items away from children.
This product is intended for indoor use only. Using this product outdoors could lead to product failure and personal injury.
Ensure that you have received all parts according to the component checklist prior to installation. If any parts are missing or faulty, contact your place of
purchase for a replacement.
Check that the product is secure and safe to use at regular intervals (at least every three months).
5
6
COUNTERBALANCE
MONITOR ARM
Instruction Manual
LDT46-C024 (2-9kg)x2
(4.4-19.8Ibs)x2
RATED
VESA Compatible
75x75 100x100 32"
MAX
Note:Adjust to the desired
angle then tighten the screws
using the Allen key as shown,
alternating from each screw
as you tighten them.
K
K

2
M-C (x4)
D5
M-B (x4)
M5x12
13
4
10-83mm10-83mm10-83mm
ø 10mm
(ø 3/8")
OR
M-A (x4)
M4x12
Too long Too Short
WARNING: Stored energy hazard!
·Firmly hold the two halves of the spring arm together and have
another person cut off the cable tie from around the spring arm.
·Slowly release the pressure on the spring arm and allow it to
gradually stretch to its full extension.
DO NOT over tighten the screws.
CAUTION
First, position and firmly hold the arm horizontally
as shown. Ask for assistance should you require it.
If the arm drops, turn the adjustment
screw counter-clockwise until it stays
in a horizontal position.
If the arm rises, turn the adjustment
screw clockwise until it stays in a
horizontal position.
K
To properly balance the arm with monitors mounted, adjust the spring tension using the
supplied Allen Key as follows:
To avoid damage to monitors or mount,
always keep the arm in a horizontal
position while making adjustments.
Again, ask for assistance if required.
CAUTION
M-A
M-B
M-C
K
3mm
M-A
M-B
M-C
A (x1)
x2
K (x1)
5mm
B (x1) D (x3)
M6x12
F (x1)
G (x1) H (x1) J (x1)
4mm
E (x2)
M6x10
I (x1)
C (x1)
OR
50-83mm50-83mm50-83mm
E
J
C
10-53mm10-53mm10-53mm
C
E
J10-83mm10-83mm10-83mm
Ø Ø10- 50mm10- 50mmØ Ø10- 50mm
A
H
I
D
G
F
D
J
BJ