
TOOLS NEEDED:
Phillips Screwdriver
ASSEMBLY INSTRUCTIONS
• Plug in power supply at rear of xture base. Only plug in
power supply to wall outlet once assembly is complete.
• Place cover over power supply box and secure screw with
Phillips screwdriver.
• Align notch at end of post with tab in the base, insert and
secure underneath base with T-shaped handled screw.
• Align notch on other end of post with tab in light bar and
tighten set screw with provided Allen wrench.
• Clean intended installation surface to remove dust or
particulates.
• Remove protective plastic lm from base.
• Plug into any 110-volt wall outlet.
USING YOUR LUX HIGHLINE LED DESK LIGHT:
• Turn light on by touching the power button on top
of the base.
• Press the power button again to cycle through the three
brightness levels and to turn light off.
• When using the light to charge your devices, unplug or
remove the devices once batteries are full.
SAFETY INFORMATION:
• The exible external power supply cable cannot be
replaced; if cable is damaged the entire power supply
must be replaced.
• For indoor use only; do not use outdoors or in damp
locations.
• Switch the light off before disconnecting power.
• Do not look directly at the LED panel when illuminated.