M.F. Blouin FP01568P10 User manual

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-1
2-Sided Black Floor Poster Stand with 10-Pocket
ASSEMBLY INSTRUCTIONS Product No. FP01568P10
Acrylic 10-Pocket
Literature Holder
Parts & Hardware
Prior to assembly, please be sure all of the parts and hardware are present.
If you are missing any hardware, please call immediately.
(2) Hex Bolts
(2) Threaded Rods
(4) Lock Knobs
(8) Acrylic Removable Pegs
(For Literature Holder)
Hex Wrench
Acrylic Sign Holder
(2) Black Legs
Black Base
Black Spacer Panel

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-2
2-Sided Black Floor Poster Stand with 10-Pocket
ASSEMBLY INSTRUCTIONS Product No. FP01568P10
Step 1:
Attach the black legs to base unit using the supplied
hex bolts & hex wrench - Position each leg keeping
keeping the top slots aligned. Hold each leg in place
while tightening the bolt(s) with the hex wrench.
DO NOT Twist the legs to tighten! Twisting the legs to
tighten may scratch the surface of the base unit.
* Be sure to keep the legs aligned so the slots are
running in the same direction to accept the sign holder
& spacer panel.
Tighten legs keeping
slots aligned

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-3
2-Sided Black Floor Poster Stand with 10-Pocket
ASSEMBLY INSTRUCTIONS Product No. FP01568P10
Step 2:
After removing the poster holder & spacer panel
from its packaging, peel off the protective film
and insert the spacer panel between the two sides
of the sign holder keeping the curved corners to
the bottom and roughly aligning the holes.
* This is a convenient time to insert your
poster(s) and is recommended but not necessary.
Step 3:
Insert the assembled poster holder & spacer
panel into the top slot of the legs roughly
aligning the holes.

M.F. BLOUIN
Merchandising Solution 710 Main St. Rollinsford, NH 03869 • 1-800-394-1632 • www.mfblouin.com • [email protected] Page-4
2-Sided Black Floor Poster Stand with 10-Pocket
ASSEMBLY INSTRUCTIONS Product No. FP01568P10
Clean unit with acrylic cleaner (or mild detergent & water) and soft cloth only. DO NOT USE ALCOHOL!
For a small container of NOVUS Acrylic Cleaner call today!
Step 4:
Align the two holes in the back of the 10-pocket literature holder
with the holes in the legs/sign holder. Insert the threaded rods
through the holes and tighten the lock knobs over each end.
Your display is now assembled!