Mansion Athletics GT-102 User manual

GYMNASTICS • MARTIAL ARTS CHEERLEADING • STUNTWORK
Space Saver Anchor Instructions • Model GT-102
STEP 1 - After determining where the apparatus will be placed, draw a rectangle 18” x 105” centered
where the bases will be. The foot anchors should be placed in the corners of this rectangle.
STEP 2 - Once the foot anchors are in, loosely bolt in the feet of all four Space Saver arms.
Swing the arms into approximate position.
STEP 3 - Using the outside base plate holes (crossed circles) measure the distances for A, B and C.
When A = A, B = B and C = C the oor layout is correct. A common dimension is A = 148”, B = 102” and C = 180”.
Mark the eight base plate holes through the base plates (9” between base anchors) and mount the base anchors.
STEP 4 - Finish bolting in the arms (3 anchors per arm and tighten.
ANCHOR
HOLE
LOCATION
View from top
LOCATION OF
BASE ANCHORS
AND MOUNTING
THE ARMS
View from top
Space Saver InStallatIon GuIde rev 12/24/15

GYMNASTICS • MARTIAL ARTS CHEERLEADING • STUNTWORK
ERECTING THE
APPARATUS &
MOUNTING THE
CABLE SYSTEM
View from top
STEP 5 - Remove end caps on each arm. If turnbuckles are used, screw them in at the bottom of each arm.
They should be adjusted so that each can be shortened or lengthened by about ten turns.
STEP 6 - Stand the apparatus up and mount the cables through the pulleys of the space saver arms. Replace
the end caps and tighten. In general, the bases are centered in relationship to the space saver feet. However,
when the old style AMF uneven bars (high bar upright is welded to the base) you may nd that the bars adjust
better when the high bar upright is about 10" closer to the center. Final step - hook up, adjust and tighten the
cables system so that the uprights are vertical and parallel with each other. A level is not absolutely necessary
here. The visual alignment with background landmarks can often result in near perfect setup.
IMPORTANT!
If there is extra
installation space
this larger
alternative footprint
will provide a more
stable cable system.
Space Saver Anchor Instructions Model
GT-102
109.75"
112.5"
Diagonal = 195.5"
29.75"
160" 9"
Page 2

Page 3

Page 4

Page 5

Page 6

Page 7

Page 8