MARLINK IRITRACK V3 Installation instructions manual

•Iritrack V3 and technical characteristics :
1) Dimensions : 180 x 112 x 53 mm (L x l x P), without bracket, plugs and cables
2) Weight : 830g
3) Consumption : 12V, 100mA on rest, 1500mA on communication
4) External power supply : Input: DC 6-42V (1A)
5) External battery : rechargeable Li-ion, 6800mAH - 3.75V
6) Internal antennas Iridium, GPS et radio
7) Microphone and speaker
•Kit composition :
1) New Iritrack bracket (New)
2) Power cable 1m with terminals (New)
3) Antenna Iridium 3m (car), 5m (truck)
4) Antenna GPS
5) Cable GPS 3m (car), 5m (truck)
114/126, avenue d’Alfortville – 94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
1
MOUNTING GUIDE KIT NEW IRITRACK V3
CAR –SSV –TRUCK
Iridium
GPS
Power
1
4
2
3
5

The power cable must be directly connected to the fuse box with permanent power supply (no
breaker –fuse 3A ).
If the configuration of your vehicle doesn’t enable it, you can connect your power cable to a
power extension (connected to the fuse box) as shown below :
1) Prepare your power cable, separating the black wire from the red and orange wires
2) Connect the power extension cable with the Iritrack power cable using terminals provided
- red & orange with red
- black with black
3) Use a plier for the connection
4) Then connect it to your battery
114/126, avenue d’Alfortville – 94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
2
POWER SUPPLY
1
4
2 3
56

Below, the New bracket and its sizes (open & closed) in millimetres (211,25 mm*134*70,5 mm).
You can open the bracket pulling the handle located at the right of the bracket.
Please make sure you have 50 mm clear on the right for cables.
114/126, avenue d’Alfortville – 94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
3
BRACKET
Before the installation of the bracket please have in mind that :
- You must have access to the Iritrack from your riding position
- You must have a clear visibility on the screen
- The top part of the Iritrack require a clear view on the windscreen to allow a perfect transmission
from the internal antennas.
It’s no more allowed to install your bracket on the roof lining of your vehicle.
Here are the drilling patterns of the bracket (same as the previous Iritrack):
-Width : 69,80 mm
- Lenght : 60.50 mm
- Drilling diameter: 5 mm

Magnetic antennas must be installed horizontally and clear of all obstacles at 180 degrees
towards the sky, on the navigation tower (metal surface).
The GPS and Iridium antennas can be side by side. It is forbidden to paint or to integrate them into
the core of the vehicle.
Connect the GPS cable to the GPS antenna and bring the GPS connector to the bracket.
Then, bring the Iridium connector to the bracket.
WARNING :
- The antenna cables should not go through the door seals but in the walls of the vehicle or via a
cable gland
- It is very important to put a shrinkable tube on each antenna / cable to couple them. Before
heating the shrinkable tube, make sure the connectors are properly locked.
Example of installations :
114/126, avenue d’Alfortville – 94600 CHOISY LE ROI –France
Tél : [phone] - Fax : [phone]
S.A.S. au capital de 236 400€ - Code TVA FR 26 334 306 172 –Code APE 6130 Z - SIREN 334 306 172 00084 –
RC 334 306 172 www.marlink.com - [e-mail]
4
ANTENNAS AND CABLES