REV.08022017
INSTALLATION GUIDEwww.maykke.com
INSTALLATION GUIDE
TOOLS AND MATERIALS NEEDED:
Installation:
ADJUSTABLE WRENCH BASIN WRENCH
Before beginning please read all installation instructions and observe all local safety and building
codes.
Inspect all products before installing. Contact Customer Service for any questions or concerns at 877.659.2858
Consult a professional if you are unfamiliar with faucet installation. We accept no liability for damages
to property or person during installation.
1. Remove the lock nut from the faucet body.
2. If the water feed tubes are not already connected, do so now. Hot water should always be on the
left and cold water should always be on the right.
3. Place the metal mounting washer, or clip, and rubber sealing gasket over the mounting hole.
4. If a decorative mounting plate is included place over the mounting hole.
5. Thread the faucet through the mounting hole and mounting hardware.
6. If a separate mounting rod is included remove the mounting nut and screw the rod into the faucet
body.
7. Thread the washer (if included) and lock nut onto the faucet tail piece from underneath the
countertop. Make sure the faucet is properly aligned and tighten the nut with your adjustable wrench.
8. Once installation is complete, turn on the water supply, making sure that no water is leaking. Leave
water on for approximately one min to insure installation is correct.
9. Connect the Pipe and the base by screwing them together and placing them in your countertop.
10. Place the rubber washer on the pipe under the countertop and secure with the lock nut.
11. Screw the soap bottle on the pipe making sure it is secured.
12. Pour liquid soap into the bottle.
13. Finish by pushing down the head of the soap dispenser.
If your faucet includes the Soap Dispenser please continue to step 9.
For warranty information please check www.maykke.com
